Enabling broad tunability, high peak and average power, ultra-short pulse duration, and all known modes of laser operation - Transition-metal (TM)-doped II-VI chalcogenides are the materials of choice for direct lasing in the mid-IR. The host materials feature broad infrared transparency, high thermal conductivity, low phonon cut-off, low optical losses, and are available as either single crystals or polycrystalline ceramics. Doped with TM ions, these media exhibit a four-level energy structure, the absence of excited state absorption, as well as broad absorption and emission bands. Doped single-crystals of high optical quality are difficult to grow; however, the advent of post-growth diffusion doped ceramics has resulted in significant progress in laser development. Here we summarize recent experimental laser results on Cr and Fe doped II-VI chalcogenides providing access to the 1.8-6 μm spectral range with a high (>60%) efficiency, multi-Watt-level (140 W in CW) output powers, tunability of >1000 nm, short-pulse (<16 fs) multi-Watt oscillation, and multi-Joule output energies in free running and gain-switched regimes. We also review recent results on hybrid fiber-bulk (Er-fiber/Er:YAG, Tm-fiber: Ho:YAG/YLF) systems combining high efficiency of CW fiber lasers with high pulse energies of bulk materials and serving as pump sources of gain-switched Cr:II-VI lasers.
We report on the spectroscopic and laser characterization of negatively charged nitrogen-vacancy (NV−) centers in diamond. Spectroscopic properties such as absorption and emission spectra as well as kinetics were studied, and parameters such as cross-sections and lifetimes were estimated. A vibronic band of NV0 with zero phonon line (ZPL) at 575 nm was detected under 532 nm pulsed excitation due to the photoionization of NV−. Transmission of 532 nm pump pulses saturate around ∼10%, which is much smaller than the theoretical level. Δk/k0 kinetics revealed slow recovery of NV− centers after photoionization under 532 nm pumping, which involved different relaxation channels depending on the probe beam wavelengths. Localization of the electrons in the metastable state of NV0 centers resulted in higher saturated transmission of 632 nm pump.
We report on room temperature gain-switched and Q-switched Fe:ZnSe lasers tunable over 3.60–5.15 µm pumped by radiation of an 2.94 µm Er:YAG laser. The maximum output energy was measured to be 5 mJ under 15 mJ of pump energy in gain-switched regime. We also demonstrated a mechanically Q-switched regime of oscillation of Fe:ZnSe lasers. This approach could be attractive for the development of high-energy short-pulse solid-state mid-IR systems operating over 3.6–5.2 µm spectral range.
We propose new transition metal (TM)-doped composite materials for mid-IR fiber lasers. The composites are the suspension of crystalline micro- and nanosized or powders in chalcogenide glasses with the refraction index matching. Mid-IR room-temperature lasing of microcomposite material is demonstrated at the wavelength.
We report a few-cycle, super-octave, polycrystalline Cr:ZnS laser system with 4 W power at 78 MHz repetition rate, where all of the necessary optical signals for the measurement of the carrier–envelope offset frequency are generated intrinsically.
We report a flashlamp pumped mechanically Q-switched (MQS) 2.94 μm Er:YAG laser based on a spinning mirror with a highest output energy of 805 mJ at a pulse duration of 61 ns and 13 MW of peak power at 1 Hz repetition rate. This record output energy was achieved with the use of 300 mm long MQS Er:YAG laser cavity consisting of a 70% output coupler, 7 × 120 mm AR coated Er(50%):YAG crystal, and 4200 rad/s angular speed of the spinning mirror. The pulse jitter was also measured by using optical triggering and was smaller than 10 ns for 150 ns Q-switched pulses, which could be applicable to many laser applications where precise synchronization of pulses is required.