We report the synthesis and characterization of Carbon and CdTe quantum dots (QDs), as well as the observed improvement in the power conversion efficiency (PCE) of photovoltaic devices upon the incorporation of the synthesized aforementioned nanostructures. Even though C quantum dots were observed to have a relatively smaller influence on solar cell performance, they are considered to be a more attractive option due to their affordability and minimal impact in the environment that could ultimately promote their widespread utilization on photovoltaic structures.

Scientific interest in luminescent solar concentrators (LSCs) has reemerged mainly due to the application of semiconductor quantum dots (QDs) as highly efficient luminophores. Recently, LSCs have become attractive proposals for Building-Integrated photovoltaics (BIPV) since they could help conventional photovoltaics to improve sunlight harvesting and reduce production costs. However, most of the modern LSCs rely on heavy-metal QDs which are highly toxic and may cause environmental concerns. Additionally, their absorption spectra give them a characteristic color limiting their potential application in BIPV. Herein, we fabricated transparent and colorless LSCs by embedding nontoxic and cost-effective zinc oxide quantum dots (ZnO QDs) in a PMMA polymer matrix (ZnO-LSC), preserving the QD optical properties and PMMA transparency. The synthesized colloidal ZnO QDs have an average size of 5.5 nm, a hexagonal wurtzite crystalline structure, a broad yellow photoluminescent signal under ultraviolet excitation, and are highly visibly transparent at the employed concentrations (>95% in wavelengths above 400 nm). The optical characterization of the fabricated ZnO-LSCs showed a good visible transparency of 80.3% average visible transmission (AVT), with an LSC concentration factor (C) of 1.02. An optimal device (ZnO-LSC-O) could reach a C value of 2.66 with the combination of optical properties of colloidal ZnO QDs and PMMA. Finally, simulations of the performance of silicon solar cells coupled to the fabricated and optimal LSCs under standard AM 1.5G illumination were performed employing the software COMSOL Multiphysics. The fabricated ZnO-LSC achieved a simulated maximum power conversion efficiency (PCE) of 3.80%, while the optimal ZnO-LSC-O reached 5.45%. Also, the ZnO-LSC generated a maximum power of 15.02 mW and the ZnO-LSC-O generated 40.33 mW, employing the same active area as the simulated solar cell directly illuminated, which generated 14.39 mW. These results indicate that the ZnO QD-based LSCs may be useful as transparent photovoltaic windows for BIPV applications.

We report the synthesis and characterization of silicon quantum dots that exhibit down-shifting, photo luminescent characteristics. We also discuss the fabrication and characterization of single crystal Silicon (c-Si) Solar cells with and without the influence of the previously mentioned QDs. The incorporation of these nanostructures triggers improvements in the performance of the fabricated photovoltaic devices, especially in the open circuit voltage (V_oc) and short circuit current density (J_sc). Specifically, the experimental results showed increments in the V_oc from 532.6 to 536.2 mV and in the J_sc from 33.4 to 38.3 mA/cm². The combined effect of those improved Voc and Jsc values led to an increment in the power conversion efficiency (PCE) from 11.90 to 13.37%. This increment represents an improvement of the order of 12.4% on the power conversion efficiency of this type of solar cells. The observed results could be conducive to promoting the proliferation of photovoltaic structures.

This paper describes the synthesis and characterization of Si and CdTe quantum dots (QDs) and their use, either on their own or combined, as photoluminescent (PL) down-shifting nanostructured coatings aimed to enhance the photovoltaic efficiency of polycrystalline silicon solar cells. To this end, the front face of a set of silicon cells was coated with different volume ratios of the above-mentioned QDs, or some of its mixtures, dispersed in PMMA layers. Previously, the absorption and the PL (exc = 380 nm) response of the dispersions of the QDs were measured. It was observed that the PL response of the mixtures was strongly affected in location, spread, and intensity of the emission peak according to the volume ratio involved. As compared to the unmixed CdTe samples, a notorious red-shift of the main peak location was obtained for a couple of mixed QDs’ dispersions, which was one of the project objectives given that Si solar cells respond better to photons with wavelengths in the 650–700 nm range. This effect was confirmed in a set of polycrystalline Si solar cells covered with and without nanostructured PMMA/QDs layers tested under AM 1.5G solar simulator conditions. It was found that the use of the proposed mixtures of QDs gave an increase of 1.53% in solar cell power conversion efficiency.