A laminate and gradient structured (LGS) AZ31 magnesium alloy was produced via a combination of surface mechanical attrition treatment (SMAT) and accumulative roll-bonding (ARB) in an attempt to improve the AZ31 strength-ductility relationship. The effects of the rolling temperature and number of passes on the microstructure and mechanical properties were researched. The LGS AZ31 Mg alloy microstructure included periodic distributions of fine grain (FG) layers, coarse grain (CG) layers, and FG layers in which the grain size exhibited a gradient transition. A depth-dependent gradient microhardness was generated because of the corresponding gradient microstructure. The effect of the LGS AZ31 Mg alloy on grain size-dependent strengthening mechanisms was researched. The yield and ultimate tensile strengths of the alloy improved dramatically and there was a slight decrease in the fracture elongation. The tensile properties of the sample present good strength-ductility relationships. This is attributed to LGS. The microstructure could change the crack propagation path and enhance alloy strength without much harm to plasticity. The overall influences of SMAT and ARB on mechanical properties, which include dynamic recrystallisation, dislocation activity, and the influences of interfaces, were researched. To illuminate the differences in the deformation behaviours of FG and CG layer microstructures, tensile test samples were imaged via SEM.
22 March 2025 in Materials Science and Engineering: A
Magnesium alloy sheets for 3C device covers require a balanced combination of high strength, high thermal conductivity and room-temperature formability, but alloying and deformation commonly degrade heat transport. This work aims to develop an industrially scalable thermo-mechanical route for Mg-Zn-Gd-Zr thin sheets and to clarify the coupled effects of precipitates, dislocations and texture. Mg-6.14Zn-6.07Gd-0.54Zr (wt.%) extruded plates were processed by multidirectional multipass hot rolling to 0.65 mm and then aged at 170 °C for 1 h. The aged sheet achieved a yield strength of 293 MPa, a thermal conductivity of 120.2 W/(m·K), and an Erichsen index (I.E.) of 4.18 mm. Rolling increased the yield strength mainly through dislocation storage and Orowan strengthening by approximately 50–60 nm precipitates, but decreased the thermal conductivity from 129.6 to 109.2 W/(m·K) because of increased solute content, phase-interface thermal resistance and dislocation scattering. Short-time aging restored the thermal conductivity by approximately 11 W/(m·K) through partial dislocation rearrangement/annihilation while maintaining high strength. Texture modification and recrystallization reduced tensile anisotropy and retained useful stretch formability. These results define a practical process window for high-thermal-conductivity Mg alloy sheets for heat-dissipation covers.