The heat storage and release capacities of phase change fabric loaded with phase change microcapsules were measured by differential scanning calorimetry (TADSCQ-2000). The melting peak splits into two sub-peaks at 20.83°C and 28.65°C, in which the heat enthalpy was 25.20 J/g, and the melting range was 16.5°C–36.8°C. The heat-conducting performance of the phase change fabric was tested using a YG (B) 606D face-plate thermometer, and the heat preservation coefficient improved to some extent from 1.05% to 32.2% than that of ordinary fabric. Contrast test was carried out for the shirt made of this fabric by the live test method. The results showed that the heat storage capacity of the phase change shirt was not enough to keep the human body maintaining a comfortable temperature for a long time on the occasions with a bigger temperature difference, thus requiring the need of other warm-keeping clothes. This phase change fabric exhibited good effects on maintaining the uniformity of body temperature and improving human comfort and could avoid low-temperature damages to four limbs in cold regions.
5 July 2022 in International Journal of Aerospace Engineering
Reverse-flow combustor is widely used for small engines to overcome high speed shaft whirling problem and to provide a low frontal area. An experimental investigation was carried out to research the flow field characteristics of a reverse-flow combustor in this paper. Different aerodynamic conditions were studied using PIV to reveal the characteristics of both the nonreacting and reacting flow fields. The structure of the nonreacting flow field in the central section shows similarity as the total pressure loss coefficient increases. The penetrating depth, jet angle, recirculation zone position, and the flow streamlines are similar, while the velocity value of the flow field increases. The structure of the reacting flow field on the central section is different from that of nonreacting flow field, but the variation trend of the reacting flow field under different pressure loss coefficient is similar to that of the nonreacting flow field. By examining the nonreacting and reacting flow fields under the same total pressure loss conditions, marked differences were observed in the primary zone close to the swirler outlet. The relative motion between fuel injection, airflow, and combustion affects the flow field in this zone. The velocity with combustion is faster than that of the nonreacting flow because of the increased temperature and heat release.
28 September 2022 in International Journal of Aerospace Engineering
The reverse-flow combustor is extensively applied in small engines due to its compact structure. The cold-state flow characteristics, the ignition process, and flame chemiluminescence characteristics of the reserve-flow combustor were investigated experimentally. Using the particle imaging velocimeter, the cold-state time-averaged flow fields at three different total pressure loss coefficients are examined. The ignition processes of the combustor, as well as flame characteristics during stable combustion at different equivalent ratios , are analyzed based on flame chemiluminescence imaging when is 3%. As increases from 1% to 5%, the flow field of the combustor remains almost unchanged while the flow velocity increases. For =3%, the ignition time drops from 26 ms to 16 ms with an increase of . In addition, the ignition performance is enhanced. Proportions of the T2 phase (quasi-stable phase) are 73%, 68%, and 66%, respectively, suggesting that the quasi-stable phase is the key to successful ignition. As increases, the flame becomes thinner and shorter. Furthermore, standard deviations of continuous image areas of and drop from 0.0143 and 0.0132 to 0.0115 and 0.0109, respectively, which indicates the enhancement of combustion stability. According to the brightness distributions of and along the axial direction of the combustor at different equivalent ratios, the production of is significantly affected by the temperature. It can be adopted as an important sign of heat release during combustion.