Chromatic confocal technology (CCT) is one of the most promising methods for the contactless and accurate measurement of structure profiles. Based on the principles of chromatic dispersion and confocal theory, a dispersion probe is proposed and optimized with several commercial and cheap refractive index lenses. The probe provides 0.3× magnification and a dispersion range of 400 μm with a commercial LED source with an effective bandwidth of ca. 450–623 nm. Since the noise fluctuation can affect the extraction stability of the focal wavelength, a modification to the centroid peak extraction algorithm is proposed in this paper, where several virtual pixels are interpolated among the real pixels of the spectrometer before thresholding. In addition, a series of experiments were carried out to test the system’s displacement measurement performance. The results clearly show that stability is improved by the modified algorithm, and the calibration repeatability is ±0.3 μm in the full measurement range with a linear stage. The standard deviation at the fixed position has an optimal value of 0.009 μm. The section profile of a Fresnel lens is measured by the CCT system to demonstrate its high feasibility and efficiency.
Chromatic confocal technology is widely used for precise, steady, and efficient displacement measurement in many industrial fields. It employs the confocal and dispersion principles to encode axial positions with the wavelengths of the reflected broad spectrum. The typical chromatic confocal sensor includes a light source, a dispersion objective, conjugate pinholes, and a spectral detection device. This study offers an overview of the current research on chromatic confocal technology. Because of its good performance in displacement detection, chromatic confocal technology has been widely used in contour measurement, biomedical imaging, and thickness measurements, as part of global and professional research. Due to its structural flexibility, it is also easily integrated into industrial equipment for in-machine and online profile measurements. It holds significant potential for future applications in industrial manufacturing and scientific research. However, there are also some challenges to be explored in terms of the broadband light source, dispersive optics design, and the balance between speed and accuracy in signal processing.
A hybrid strategy is proposed to meet the challenge of obtaining the profile of micro gear teeth with a small modulus. Firstly, the contact probe segmentally obtained the falling flank profiles with an auxiliary lifting mechanism to avoid interference when it climbs on the rising slope. Then, the noncontact chromatic confocal displacement sensor efficiently acquired the gear peak positions to carry out the two-point error separation with the gear peak positions from the probe measurement. Finally, actual experiments were carried out to obtain the profile of a harmonic drive flexspline. Compared with the commercial ultraprecise profiler, the proposed method provides measurement results with a deviation of less than 20 μm. In conclusion, the hybrid strategy is feasible and accurate for drawing the micro gear teeth profile without any collision between the measuring probes and the measured workpiece.