Manoj Sachdev

Prof. Manoj Sachdev

orcid

Research Focus & Metrics

Academic Career Length

35Years (1992-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 October 2006 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
Verified
Journal Article
Closed access
MMM. Maymandi-Nejad
M. Maymandi-Nejad
MSManoj Sachdev
Manoj Sachdev
In this paper, the application of dynamic threshold MOS (DTMOS) technique for low-voltage analog circuits is explored. The body terminal of PMOS transistors in bulk CMOS technology can be used as the forth terminal to enhance the performance of low-voltage analog circuits. To show the effectiveness of this technique, we have designed a continuous time common mode feedback (CMFB) circuit for a sub 1-V opamp and a new sub 1-V, 1-bit quantizer. A 0.8-V opamp with embedded CMFB and a 0.8-V, 1-bit quantizer for low-voltage DeltaSigma modulators are implemented in 0.18-mum CMOS technology. The simulation results as well as the measurement data of these blocks are presented in this paper

27 May 2021 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
DPDhruv Patel
Dhruv Patel
ANAdam Neale
Adam Neale
DWDerek Wright
Derek Wright
MSManoj Sachdev
Manoj Sachdev
This paper proposes a Differential-Input Body Bias Sense Amplifier (DIBBSA) with an auto-offset mitigation feature suitable for low-voltage SRAMs where the differential bitline signals are applied to the sources as well as to the body of the critical sensing transistors. We simulated and fabricated the proposed DIBBSA architecture with various operational modes in 65-nm CMOS technology to analyze body biasing's effectiveness in mitigating the offset. The standard deviation of offset ( σ OS ) was measured over 5120 SAs in 10 ICs. The iso-gate area reduction in σ OS for the proposed DIBBSA-FL and DIBBSA-PD modes resulted in 68.1% and 61.9% compared to conventional Current Latch SA (CLSA) and 24.1% and 18.1% compared to Voltage Latch SA (VLSA) at 0.4 V supply and 25 °C, respectively. Carried out measurements on 512 SAs in an IC show the minimum required differential input voltage across the temperature range of 0 °C to 75 °C at 0.4 V is achieved to be 48% lower compared to CLSA and 28% lower compared to VLSA by both the DIBBSA-FL and DIBBSA-PD modes.

1 January 1992 in IEEE Transactions on Industry Applications
Verified
Journal Article
Closed access
TSTarlochan Sidhu
Tarlochan Sidhu
MSManoj Sachdev
Manoj Sachdev
HWH.C. Wood
H.C. Wood
The design, development, and implementation of a computer-aided design (CAD) tool for developing digital controllers and relays are presented. The development includes modeling A/D converters, software, and the necessary logic. Procedures for modeling A/D converters and simulating the software are described. Application of the CAD tool is demonstrated by evaluating and comparing three different designs of a digital overcurrent relay. The designs are evaluated to determine both the speed and accuracy of the relays. The effects of the size of the A/D converters, the word-size used in computations, and the truncation/rounding are included in the simulation. Also described is the algorithm used in the relay design.

5 March 2019 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
DPDhruv Patel
Dhruv Patel
ANAdam Neale
Adam Neale
DWDerek Wright
Derek Wright
MSManoj Sachdev
Manoj Sachdev
Sense amplifier (SA) input-referred offset often dictates the minimum required differential input (Δ VBL-min) and is an important factor in realizing low-voltage static random access memories. This paper presents a HYbrid latch-type Sense Amplifier (HYSA-QZ), where the bitline signals are supplied to multiple internal nodes to significantly reduce Δ VBL-min. A 65-nm CMOS test chip with arrays of the HYSA-QZ, two intermediate formulations of the HYSA-QZ, conventional current latch SA (CLSA), and conventional voltage latch SA (VLSA) were fabricated. Measurements over 5120 SAs of each type show that the HYSA-QZ implemented with regular-V T transistors require 50.0%, and 22.8% lower Δ VBL-min with 6.5% (or 4.5%) and 30.7% (or 18.8%) of total gate (or layout) area overhead compared to CLSA and VLSA at 0.4 V, respectively. Iso-gate-area offset improvement was substantiated with Pelgrom's mismatch model, where the HYSA-QZ with regular- V T transistors showed 46.6% and 7.7% improvements in measured standard deviation of offset distribution compared with CLSA and VLSA, respectively. Measured Δ VBL-min for the HYSA-QZ remains stable and low over a temperature range from 0 °C to 75 °C at 0.4 V. Moreover, an additional 13.0% reduction in Δ VBL-min was measured in the HYSA-QZ when using low-V T transistors. Finally, the HYSA-QZ operates reliably at VDD-min of 260 mV in 25 °C.

23 January 2018 in IEEE Solid-State Circuits Letters
Verified
Journal Article
Closed access
DPDhruv Patel
Dhruv Patel
MSManoj Sachdev
Manoj Sachdev
An offset tolerant SRAM sense amplifier (SA) deployed with sample-boost-latch technique to facilitate both common mode and differential mode boosting is proposed. The common mode boosting enables proposed SA, SBLSA to operate deeper into the subthreshold regime whereas the differential mode boosting helps tolerate undesirable mismatch conditions by driving cross-coupled inverters with boosted differential voltages. The proposed boosting circuit first samples the bitline voltages and then isolates the sampled voltages from the highly capacitive bitlines followed by the boosting phase on relatively much less internal input capacitances of the latch. Arrays of SBLSA and conventional voltage latch SA (VLSA) were fabricated in 65-nm-GP CMOS (512 each). At 25 °C, SBLSA achieves 23.3% reduction in directly measured standard deviation of input-referred offset (across 16 ICs, 8192 SAs) and 38.5% improvement (typical IC) in sensing delay at 0.3 V. SBLSA offers reliable operation across entire temperature range of -25 °C to 85 °C at 0.35 V whereas it is 0.41 V for VLSA. Finally, SBLSA operates reliably at the minimum supply of 0.23 V at 25 °C which is 30 mV less compared to VLSA.

19 September 2022 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
Verified
Journal Article
Closed access
KSKleber Stangherlin
Kleber Stangherlin
MSManoj Sachdev
Manoj Sachdev
Secret keys can be extracted from the power consumption or electromagnetic emanations of unprotected devices. Traditional countermeasures have a limited scope of protection and impose several restrictions on how sensitive data must be manipulated. We demonstrate a bit-serial RISC-V microprocessor implementation with no plain-text data. All values are protected using Boolean masking. Software can run with little to no countermeasures, reducing code size and performance overheads. Unlike previous literature, our methodology is fully automated and can be applied to designs of arbitrary size or complexity. We also provide details on other key components, such as clock randomizer, memory protection, and random number generator (RNG). The microprocessor was implemented in 65-nm CMOS technology. Its implementation was evaluated using NIST tests and side-channel attacks. Random numbers generated with our RNG pass on all NIST tests. The side-channel analysis on the baseline implementation extracted the advanced encryption system (AES) key using only 375 traces, while our secure microprocessor was able to withstand attacks using 20M traces.