The paper presents a comparison of six recently introduced multiaxial fatigue strength estimation criteria to four methods, the large-scope validation of which has already been published. The results obtained for each newer method are analyzed and discussed. From the newer methods, only the criterion by Böhme reaches an estimation quality similar to the best performing criteria. The validation was performed on the FatLim data sets, but the primary focus of the paper is set to analyzing the validation on a smaller AMSD25 data set derived from it. The comparison shows that the application of AMSD25 for validation practice allows users to reduce the number of evaluated test cases, while generally preserving the worst cases showing the weaknesses of various estimation methods.
A knurled interference fit is a machine part connection made by a plastic joining, which includes the advantages of commonly-used shaft-hub-connections. The combination of the friction and form fit, which are responsible for torque transmission, results in a higher power density than conventional connections. In this paper, parameter gaps are bridged with the aim of enhance the design calculation of the knurled interference fit. Experimental investigations on the shaft chamfer angle (100Cr6) and hub-diameter-ratio (AlSi1MgMn) were performed. The analytical approaches are developed for calculating the joining force and maximal torque capacity by accounting for experimentally investigated loss of load transmission at high hub-diameter-ratios and high shaft chamfer angles. The presented calculation approach is an accurate tool for the assessment of early machine designs of the knurled interference fit and helps to save from having to perform time-extensive tests.
12 February 2024 in International Journal of Fatigue
The joining of machine parts by plastic forming is a common method for transmitting forces and torque. In drive trains, the ‘knurled interference fit’ has a high transmission capacity through the combination of frictional connection and form fit. In the present study, the shaft specimen made of C45 steel material is joined with an inner knurled hub made of 16MnCr5 case hardened steel. The influence of the joining process parameters on the torsional fatigue strength of the shaft-hub connection is investigated by means of experimental studies. The most important parameter is the chamfer angle of the knurled hub, which determines the rate of strain hardening in the material and differs between the cutting and forming joining processes. This study shows that knurled interference fit connections joined by forming achieve a higher fatigue strength and a higher maximum static torque than connections joined by cutting.