Engineers widely use topology optimization during the initial process of product development to obtain a first possible geometry design. The state-of-the-art method is iterative calculation, which requires both time and computational power. This paper proposes an AI-assisted design method for topology optimization, which does not require any optimized data. An artificial neural network—the predictor—provides the designs on the basis of boundary conditions and degree of filling as input data. In the training phase, the so-called evaluators evaluate the generated geometries on the basis of random input data with respect to given criteria. The results of those evaluations flow into an objective function, which is minimized by adapting the predictor’s parameters. After training, the presented AI-assisted design procedure generates geometries that are similar to those of conventional topology optimizers, but require only a fraction of the computational effort. We believe that our work could be a clue for AI-based methods that require data that are difficult to compute or unavailable.
This article deals with a novel active bending soft body that uses metamaterials and combines soft behavior, integrated actuation, low complexity, and a high density of producible forces and moments. The presented concept consists of a tube-like structure with tailored, unconventional material properties, which enable the generation of a bending deformation and/or moment when circumferential stress and/or strain is induced. Circumferential actuation can be generated by a difference in pressure between the internal and external surface of the tube or, alternatively, by distributed expansion actuators that act radially or tangentially (e.g., shape memory wires). In addition to an analytical model, this article also presents a design procedure and deals with the implementation of the proposed concept in a functional prototype and its experimental characterization.
The paper presents a comparison of six recently introduced multiaxial fatigue strength estimation criteria to four methods, the large-scope validation of which has already been published. The results obtained for each newer method are analyzed and discussed. From the newer methods, only the criterion by Böhme reaches an estimation quality similar to the best performing criteria. The validation was performed on the FatLim data sets, but the primary focus of the paper is set to analyzing the validation on a smaller AMSD25 data set derived from it. The comparison shows that the application of AMSD25 for validation practice allows users to reduce the number of evaluated test cases, while generally preserving the worst cases showing the weaknesses of various estimation methods.
The coefficient of friction (COF) is an important parameter for mechanical engineers to consider when designing frictional connections. Previous work has shown that a surface microstructuring of the harder friction partner leads to a significant increase in the COF. However, the impact of the changes in the tribological system on the COF are not known in detail. In this study, the tribological influence factors such as the nominal surface pressure, the material pairing, lubrication, and the surface properties of the counterbody are investigated. Microstructuring is applied by turn-milling of an annular contact surface of cylindrical specimens. A torsional test bench is used to measure the torque depending on the displacement of the two specimens, thus enabling the determination of the COF. All tests with the microstructured specimens result in higher COF than the reference test with unstructured samples. The manufacturing process of the counterbody surface, the nominal surface pressure, and the materials in contact have a significant influence on the COF. While lubrication reduces friction in the case of unstructured specimens, the COF does not change significantly for microstructured samples. This proves that the deformative friction component dominates over the adhesive. Microstructuring the harder friction partner increases the transmittable torque in frictional connections and reduces the sensitivity towards possible contamination with lubricants.
The sensory acquisition of in situ data in technical systems is one of the key requirements set by ongoing digitalization. The sensory utilization of mechanical design elements is a step towards the accomplishment of this requirement. To set a common ground for further research in the context of sensory utilizable design elements, this paper reviews the current state of research in this topic. First, the aim, potentials and classification of sensory utilizable design elements are introduced. Next, examples of sensory utilizable design elements are presented. These examples are used to demonstrate the technical and methodical challenges that have to be addressed in order to establish sensory utilizable design elements as a solution for the requirements of digitalization.