This paper presents the design and simulation of a neural sliding mode controller (NSMC) for a regenerative braking system in an electric vehicle (EV). The NSMC regulates the required current and voltage of the bidirectional DC-DC buck–boost converter, an element of the auxiliary energy system (AES), to improve the state of charge (SOC) of the battery of the EV. The controller is based on a recurrent high-order neural network (RHONN) trained using the extended Kalman filter (EKF) and the unscented Kalman filter (UKF) as the tools to train the neural networks to obtain a higher SOC in the battery. The performance of the controller with the two training algorithms is compared with a proportional integral (PI) controller illustrating the differences and improvements obtained with the EKF and the UKF. Furthermore, robustness tests considering Gaussian noise and varying of parameters have demonstrated the outcome of the NSMC over a PI controller. The proposed controller is a new strategy with better results than the PI controller applied to the same buck–boost converter circuit, which can be used for the main energy system (MES) efficiency in an EV architecture.

This paper presents two intelligent robust control strategies applied to manage the dynamics of a DC-DC bidirectional buck–boost converter, which is used in conjunction with a supercapacitor as an auxiliary energy system (AES) for regenerative braking in electric vehicles. The Neural Inverse Optimal Controller (NIOC) and the Neural Sliding Mode Controller (NSMC) utilize identifiers based on Recurrent High-Order Neural Networks (RHONNs) trained with the Extended Kalman Filter (EKF) to track voltage and current references from the converter circuit. Additionally, a driving cycle test tailored specifically for typical urban driving in electric vehicles (EVs) is implemented to validate the efficacy of the proposed controller and energy improvement strategy. The proposed NSMC and NIOC are compared with a PI controller; furthermore, an induction motor and its corresponding three-phase inverter are incorporated into the EV control scheme which is implemented in Matlab/Simulink using the “Simscape Electrical” toolbox. The Mean Squared Error (MSE) is computed to validate the performance of the neural controllers. Additionally, the improvement in the State of Charge (SOC) for an electric vehicle battery through the control of buck–boost converter dynamics is addressed. Finally, several robustness tests against parameter changes in the converter are conducted, along with their corresponding performance indices.