With the aim to solve the problem of the non-linear phenomenon of the satellite power system under the influence of the space environment factors, which threatens the stability of the power system, in this paper, the abnormal charging and discharging of solar arrays and solar array drive assembly (SADA) induced by the space plasma environment and accidental events, such as debris impact, and the non-linear behaviors of the solar array and load during the Earth eclipse are modeled and analyzed. On this basis, the hazard risk evaluations of the above non-linear phenomena are carried out, and the weak links of the satellite power system in the space environment are identified. The results show that the unexpected energy of the solar array will increase the current stress and power loss of the power device, resulting in S3R over-regulation. An SADA arc fault will reduce the power supply capacity of the solar array, damage the shunt regulator, and affect the quality of the bus. The non-linear behavior of the solar array and load during the Earth eclipse may damage the battery charge and discharge regulator, seriously affecting the stability of the power system.
In this paper, the characteristics of the primary arc and secondary arc on a solar array in low earth orbit (LEO) are investigated. The vacuum plasma environment in LEO has been used to study the primary arc and secondary arc of a high-voltage solar array. Silicon solar cells with rigid substrate specimens are used for the experiment. The series-parallel spacing of the silicon solar cells is 1 mm. The string currents of the solar cells are 0.7 A, 1.5 A and 2 A. The primary arc and secondary arc are photographed by high-speed cameras. The differences between the primary arc and secondary arc are observed. The secondary arc can be observed before the primary arc is extinguished. The primary arc is a single arc when the string current is 0.7 A. Multiple arc columns are accompanied by higher arc current. Two arc columns of the primary arc can be observed at 1.5 A string current and 2 A string current. The multiple primary arc columns are related to higher bias voltage. The threshold for sustained arcing is near 145 V/0.7 A, 105 V/1.5 A and 100 V/2 A at 1 mm string gap. Moreover, the transition time of secondary arc formation is analyzed, and found to be about 10–13 μs. The string currents, string voltages and primary arc have no effect on the transition time of the secondary arc formation.