Xiang Gao

Mr. Xiang Gao


Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 January 2014 in Journal of Engineering for Gas Turbines and Power
Verified
Journal Article
Closed access
PDF file
CZChenkai Zhang
Chenkai Zhang
HJHu Jun
Hu Jun
ZWZhiqiang Wang
Zhiqiang Wang
XGXiang Gao
Xiang Gao
Low-speed model testing has advantages such as great accuracy and low cost and risk, so it is widely used in the design procedure of the high pressure compressor (HPC) exit stage. The low-speed model testing project is conducted in Nanjing University of Aeronautics and Astronautics (NUAA) to represent aerodynamic load and flow field structure of the seventh stage of a high-performance ten-stage high-pressure compressor. This paper outlines the design work of the low speed four-stage axial compressor, the third stage of which is the testing stage. The first two stages and the last stage provide the compressor with entrance and exit conditions, respectively. The high-to-low speed transformation process involves both geometric and aerodynamic considerations. Accurate similarities demand the same Mach number and Reynolds number, which will not be maintained due to motor power/size and its low-speed feature. Compromises of constraints are obvious. Modeling principles are presented in high-to-low speed transformation. Design work was carried out based on these principles. Four main procedures were conducted successively in the general design, including establishment of low-speed modeling target, global parameter design of modeling stage, throughflow aerodynamic design, and blading design. In global parameter design procedure, rotational speed, shroud diameter, hub-tip ratio, midspan chord, and axial spacing between stages were determined by geometrical modeling principles. During the throughflow design process, radial distributions of aerodynamic parameters such as D-factor, pressure-rise coefficient, loss coefficients, stage reaction, and other parameters were obtained by determined aerodynamic modeling principles. Finally, rotor and stator blade profiles of the low speed research compressor (LSRC) at seven span locations were adjusted to make sure that blade surface pressure coefficients agree well with that of the HPC. Three-dimensional flow calculations were performed on the low-speed four-stage axial compressor, and the resultant flow field structures agree well with that of the HPC. It is worth noting that a large separation zone appears in both suction surfaces of LSRC and HPC. How to diminish it through 3D blading design in the LSRC test rig is our further work.

12 January 2016 in International Journal of Turbo & Jet-Engines
Verified
Journal Article
Closed access
ZWZhiqiang Wang
Zhiqiang Wang
SXShen Xigang
Shen Xigang
HJHu Jun
Hu Jun
XGXiang Gao
Xiang Gao
LLLiu Liping
Liu Liping
A numerical method was developed to predict the aerodynamic stability of a high bypass ratio turbofan engine, at the landing stage of a large transport aircraft, when the thrust reverser was deployed. 3D CFD simulation and 2D aeroengine aerodynamic stability analysis code were performed in this work, the former is to achieve distortion coefficient for the analysis of engine stability. The 3D CFD simulation was divided into two steps, the single engine calculation and the integrated aircraft and engine calculation. Results of the CFD simulation show that with the decreasing of relative wind Mach number, the engine inlet will suffer more severe flow distortion. The total pressure and total temperature distortion coefficients at the inlet of the engines were obtained from the results of the numerical simulation. Then an aeroengine aerodynamic stability analysis program was used to quantitatively analyze the aerodynamic stability of the high bypass ratio turbofan engine. The results of the stability analysis show that the engine can work stably, when the reverser flow is re-ingested. But the anti-distortion ability of the booster is weaker than that of the fan and high pressure compressor. It is a weak link of engine stability.