This work considers the ability of carbon-nanotube (CNT)-coated plasma to inactivate bioaerosols. Escherichia coli (E. coli) and λ virus phage were chosen as the challenge bioaerosols. A test chamber was used to simulate an indoor environment and to control the air exchange rate (ACH). The results demonstrated that CNT-coated plasma had a significant antimicrobial effect on both bacterial and viral bioaerosols. The experimental results revealed that CNT-coated plasma under an operating voltage of 6.0 kV and an ACH of 0.5 h−1 had significantly higher bioaerosol inactivating ability (kCNT, 0.24 and 0.23 min−1 for E. coli and λ virus phage, respectively) compared to the results without using CNT-coated plasma (kn, 0.09 and 0.08 min−1 for E. coli and λ virus phage, respectively). Under the higher ACH condition, the system demonstrated higher bioaerosol removal efficiency due to the mechanical effect of clean air exchange. Increasing flow rate and operating voltage could raise the inactivating ability of the CNT-coated plasma system. A CNT-coated plasma air-cleaning device was tested in a real indoor medical environment and yielded bacterial bioaerosol removal efficiency in the range from 70% to 80% within 6 h of operation (7.5 Lpm and 6.0 kV), which suggests that CNT-coated plasma treatment has the potential for further application in improving indoor air quality.
This study aimed to examine whether different agricultural work patterns may cause MSDs in different body areas and assess their severity. In previous studies, musculoskeletal disorders (MSDs) have been recognized as an occupational disease in agricultural workers. However, not all MSDs resulting from agriculture occur in the same body areas or have similar severity. This study conducted a questionnaire survey to inquire about the body areas and severity of MSDs among fruit farmers. A total of 212 valid answers were collected. Subsequently, their main harvesting postures were classified into three groups to examine the differences in MSD occurrence and severity among those groups. The results indicate that the harvesting posture did result in different severities of MSDs in certain body areas. Raising hands above the shoulders caused significantly higher MSD severity in the neck, shoulder, upper back, and elbows despite the same standing posture. Additionally, those who squatted, bent, or kneeled had a significantly higher severity of MSDs in the shoulders compared to those who stood but did not raise their hands above their shoulders. This study confirmed that the different harvesting heights of fruits can affect farmers’ posture, leading to differences in the body areas affected by, and severity of, MSDs.
Open-air asphalt milling generates hazardous respirable crystalline silica (RCS), posing severe risks to operators of legacy machines lacking enclosed cabs. This study evaluates a novel, standalone retrofit water spray system designed to intercept fugitive dust. Field validation across 11 road maintenance sites involved particle characterization and paired system-off/on exposure monitoring. Results indicated a Mass Median Aerodynamic Diameter (MMAD) of 6.12 µm, confirming the efficacy of fine-atomizing nozzles (0.3 mm) for capturing respirable fractions. The system achieved RCS suppression efficiencies ranging from 60% to over 85% under low-to-moderate wind conditions (<2.5 m/s). A comparative analysis revealed no significant performance gain from larger 0.5 mm nozzles, supporting the use of smaller orifices for optimal water conservation. However, suppression efficacy degraded significantly when crosswinds exceeded 2.5 m/s, identifying a critical operational threshold. This retrofit solution provides a scientifically validated, cost-effective engineering control for reducing occupational silica exposure in aging road maintenance fleets.
Open-air asphalt milling generates hazardous respirable crystalline silica (RCS), posing severe risks to operators of legacy machines lacking enclosed cabs. This study evaluates a novel, standalone retrofit water spray system designed to intercept fugitive dust. Field validation across 11 road maintenance sites involved particle characterization and paired system-off/on exposure monitoring. Results indicated a Mass Median Aerodynamic Diameter (MMAD) of 6.12 µm, confirming the efficacy of fine-atomizing nozzles (0.3 mm) for capturing respirable fractions. The system achieved RCS suppression efficiencies ranging from 60% to over 85% under low-to-moderate wind conditions (<2.5 m/s). A comparative analysis revealed no significant performance gain from larger 0.5 mm nozzles, supporting the use of smaller orifices for optimal water conservation. However, suppression efficacy degraded significantly when crosswinds exceeded 2.5 m/s, indicating a potential operational boundary. This retrofit solution provides a scientifically validated, cost-effective engineering control for reducing occupational silica exposure in aging road maintenance fleets.
Airborne viral transmission necessitates effective indoor air purification strategies. Conventional methods often face operational challenges, including potential secondary aerosolization and performance degradation under high-humidity conditions. This study evaluates a hybrid control system integrating a multi-walled carbon nanotube (MWCNT) field-emission plasma with a UV-LED/TiO2 photocatalyst to continuously inactivate airborne bacteriophages. The system’s performance was assessed under varying applied voltages and relative humidity (RH) levels. The kinetic results demonstrated that the hybrid configuration yields a synergistic inactivation effect compared to the isolated plasma or photocatalytic treatments. Based on the kinetic enhancement, it is hypothesized that trace ozone generated by the plasma discharge serves as an electron acceptor on the UV-illuminated TiO2 surface, thereby mitigating electron–hole recombination and enhancing the generation of hydroxyl radicals (·OH). Furthermore, the hybrid system exhibited operational resilience under high-moisture conditions, maintaining a robust active inactivation constant (ka = 0.190 min−1) at 70% RH without statistical degradation. This stability indicates that the continuous field emission effectively utilizes ambient moisture for secondary radical generation rather than being quenched by water condensation. Ultimately, this hybrid technology presents a continuous and adaptable engineering control measure for mitigating airborne pathogens in enclosed occupational environments, including those in high-humidity climates.