From the results of the three round-robin tests on electrochemical noise (EN) measurements with dummy cells performed between 2014 and 2017 by the European Cooperative Group on Corrosion Monitoring of Nuclear Materials, it was concluded that achieving valid EN measurements is jeopardized by a lack of theoretical knowledge as well as by software and hardware issues. This paper is aimed at guiding users of the EN technique by providing the minimum knowledge for EN measurements, including the necessary validation of the signals measured at different sampling frequencies by calculation of their power spectral densities. Two practical works performed with a commercial potentiostat are proposed. The first one is devoted to the measurement of the thermal noise of three resistors of equal value connected in a “star” arrangement and used in the conventional three-electrode EN measurement setup using a zero-resistance ammeter. This allows the instrumental noise of the equipment to be determined. The second practical work concerns pitting corrosion of two identical aluminum electrodes in potassium chloride to show that the noise impedance is equal to the modulus of the impedance of the electrodes, which is another way to validate the EN measurements. A bias voltage is then applied between the electrodes to obtain one anode and one cathode, which shows the difficulty of analyzing the measured EN in asymmetric systems.

A magnetic frequency mixing technique with a set of miniaturized planar coils was investigated for use with a completely integrated Lab-on-Chip (LoC) pathogen sensing system. The system allows the detection and quantification of superparamagnetic beads. Additionally, in terms of magnetic nanoparticle characterization ability, the system can be used for immunoassays using the beads as markers. Analytical calculations and simulations for both excitation and pick-up coils are presented; the goal was to investigate the miniaturization of simple and cost-effective planar spiral coils. Following these calculations, a Printed Circuit Board (PCB) prototype was designed, manufactured, and tested for limit of detection, linear response, and validation of theoretical concepts. Using the magnetic frequency mixing technique, a limit of detection of 15 µg/mL of 20 nm core-sized nanoparticles was achieved without any shielding.