Exiting green building assessment standards sometimes cannot work well for large-scale public buildings due to insufficient attention to the operation and maintenance stage. This paper combines the theory of life cycle assessment (LCA) and building information modeling (BIM) technology, thereby proposing a green building assessment method by calculating the greenhouse gas emissions (GGE) of buildings from cradle to grave. Life cycle GGE (LCGGE) can be divided into three parts, including the materialization stage, the operation and maintenance stage, and the demolition stage. Two pieces of BIM software (Revit and Designbuilder) are applied in this study. A museum in Guangdong, China, with a hot summer and warm winter is selected for a case study. The results show that BIM can provide a rich source of needed engineering information for LCA. In addition, the operation and maintenance stage plays the most important role in the GGE reduction of a building throughout the whole life cycle. This research contributes to the knowledge body concerning green buildings and sustainable construction. It helps to achieve the reduction of GGE over the whole life cycle of a building. This is pertinent to contractors, homebuyers, and governments who are constantly seeking ways to achieve a low-carbon economy.

The force mechanism and progressive collapse of steel tube-coupler scaffolds were studied under a local load. A distributed optical fiber system was used to conduct experiments on four different scaffold erections. The stresses of the vertical rods, horizontal rods and braces had ladder-like distributions; braces sustained most of the axial force, whereas vertical and horizontal rods sustained an axial force and bending moment. A reasonable numerical analysis strategy is established on the basis of this research and a comparison with experiments, and the progressive collapse process is simulated using ANSYS software. Horizontal rods and braces not only provide auxiliary support for the vertical rods, but also contribute to forces throughout the scaffold; internal forces pass through the two types of bar and are redistributed in each vertical rod such that all vertical rods are associated with forces in the scaffold. Braces block the spread of local collapse within the same floor while bottom horizontal rods block that from one floor to another. The addition of braces and bottom horizontal rods can therefore effectively prevent progressive collapse.

This paper proposes an asymmetric hybrid tri-stable piezoelectric energy harvester for rotational motion (RHTPEH). The device features an asymmetric tri-stable piezoelectric cantilever beam positioned at the edge of a rotating disk. This beam is uniquely configured with an asymmetric arrangement of magnets. Additionally, an elastic amplifier composed of a vertical and a rotating spring connects the beam’s fixed end and the disk. This setup enhances both the rotational amplitude and vertical displacement of the beam during motion. A comprehensive dynamical model of the RHTPEH was developed using Lagrange’s equations. This model facilitated an in-depth analysis of the system’s behavior under various conditions, focusing on the influence of key parameters such as the asymmetry in the potential well, the stiffness ratio of the amplifier springs, the radius of the disk, and the disk’s rotational speed on the nonlinear dynamic response of the system. The results show that the asymmetric hybrid tri-stable piezoelectric energy harvester makes it easier to harvest the vibration energy in rotational motion and has excellent power output performance compared with the symmetric tri-stable piezoelectric energy harvester. The output power magnitude of the system at higher rotational speeds increases as the radius of rotation expands, but when the rotational speed is low, the steady-state output power magnitude of the system is not sensitive to changes in the radius of rotation. Theoretical analysis and numerical simulations validate the effectiveness of the proposed asymmetric RHTPEH for energy harvesting in low-frequency rotating environments.