The aim of this project is to fabricate fiber mats and hydrogel materials that constitute the two main components of a wound dressing material. The contributions of boric acid (BA) and zinc oxide (ZnO) to the physical and mechanical properties of polycaprolactone (PCL) is investigated. These materials are chosen for their antimicrobial and antifungal effects. Additionally, since chitosan forms brittle hydrogels, it is reinforced with polyvinyl alcohol (PVA) to improve ductility and water uptake properties. For these purposes, PCL, BA, ZnO, PVA, and chitosan are used in different ratios to fabricate nanofiber mats and hydrogels. Mechanical, physical, and chemical characteristics are examined. The highest elastic modulus and tensile strength are obtained from samples with 6% BA and 10% ZnO concentrations. ZnO-decorated fibers exhibit a higher elastic modulus than those with BA, though BA-containing fibers exhibit greater elongation before breakage. All fibers exhibit hydrophobic properties, which help to prevent biofilm formation. In compression tests, CS12 demonstrates the highest strength. Increasing the PVA content enhances ductility, while a higher concentration of chitosan results in a denser structure. This outcome is confirmed by FTIR and swelling tests. These findings highlight the optimal combinations of nanofibrous mats and hydrogels, offering guidance for future wound dressing designs that balance mechanical strength, water absorption, and antimicrobial properties. By stacking these nanofibrous mats and hydrogels in different orders, it is expected to achieve a wound care material that is suitable for various applications. The authors encourage experimentation with different configurations of these nanofiber and hydrogel stackings to observe their mechanical behavior under real-life conditions in future studies.
28 June 2022 in İstanbul Ticaret Üniversitesi Fen Bilimleri Dergisi
A study about long-term corrosion behavior of anodized and non-anodized Ti6Al4V and MgAZ31B biomaterials was conducted under controlled conditions. By applying 20V DC potential, MgAZ31B alloys was anodized in phosphoric acid and potassium hydroxide while Ti6Al4V alloys was anodized in phosphoric acid and oxalic acid. Long-term experiments were carried out by immersing them in deionized (DI) water, 3% NaCl and phosphate-buffered saline (PBS) solutions. The corrosion rate and pattern were measured by electrochemical analysis. Also, as a result of anodization, the natural oxide layer was observed on the material surface, thus the corrosion rate is reduced and the life of the biomaterial has been improved.
18 December 2025 in İstanbul Ticaret Üniversitesi Fen Bilimleri Dergisi
In this study, the mechanical characteristics of carbon fiber-epoxy composites containing different ratios of SiO₂ and TiO₂ microparticles in their matrix, produced from nine sheets by hand lay-up, were investigated. The layer orientations of the composites were compared in different configurations and optimized, and the suitable ply sequence [0° / +45° / -45° / 90° / 0° / 90° / -45° / +45° / 0°] was determined. The specimens evaluated within the scope of the experiment were prepared in accordance with ASTM-D638 and ASTM E23 standards, and tensile and Charpy impact tests were performed. Composite plates were fabricated with four different microparticle ratios by mass (0, 1%, 2%, and 4%). In the tensile tests, the composite containing 1% SiO₂-TiO₂ microparticles was observed to exhibit a 4,33% increase in ultimate tensile strength compared to the composite without microparticles. Tensile strength and impact strength data obtained from the tests were compared and presented. The aim of this research was to investigate the effects of adding SiO₂ and TiO₂ microparticles in various ratios on the mechanical properties of the composites. Tensile and Charpy impact tests were used to evaluate these effects.