Raw materials are used in many industrial technologies. The raw material frequently has to be prepared as an intermediate with an appropriate particle size distribution, which requires the use of grinding. In grinding processes, energy consumption is a very important profitability criterion for the applied particular size reduction technology. The paper describes the comminution process that takes place in the jet mill using a modified form of the thermodynamic theory of grinding. In this theory, new material characteristics have been added: the surface and volumetric density of grinding energy. The thermodynamic theory is a combination of the classical Kick’s theory and the modified form of Rittinger’s theory. The tested physical magnitudes are a measure of the energy consumption of the grinding process. They describe the energy that must be provided in the grinding process to overcome interactions between particles related to the volume and surface of the material. Knowledge of these magnitudes is necessary to model thermomechanical phenomena in the solid state. The paper presents the results of research on comminution in a jet mill, on the basis of which the values of the tested material magnitudes were determined. It is graphically shown how the values of the tested magnitudes depend on the grain size of the ground samples.
Heating steel charges is essential for proper charge formation. At the same time, it is a highly energy-intensive process. Limiting the scale formed is critical for reducing heat consumption in this process. This paper applies fuzzy logic to model heating and scale formation in industrial re-heating furnaces. Scale formation depends on the temperature of the initial charge, heating time, excess air coefficient value, and initial scale thickness. These parameters were determined based on experimental tests, which are also the inputs in the model of the analyzed process. The research was carried out in walking beam furnaces operating in hot rolling mill departments. To minimize the excess energy consumption for heating a steel charge in an industrial furnace before forming, a heating and scale formation (HSF) model was developed using the fuzzy logic-based approach. The developed model allows for the prediction of the outputs, i.e., the charge’s final surface temperature and the scale layer’s final thickness. The comparison between the measured and calculated results shows that the model’s accuracy is acceptable.
10 June 2013 in Advances in Science and Technology Research Journal
One of the methods of analyzing a heat exchanger consists in determining the heat transfer rates and outlet temperatures of the fluids for known mass flows, inlet temperatures, and exchanger type and size. This requires calculating the exchanger performance for known transfer surface area but unknown outlet temperatures. The concept of the heat transfer effectiveness (HTE) can be applied to determine the heat transfer rate of the specified heat exchanger without knowing the outlet temperatures of the fluids. This article presents the results of calculations of the HTE parameter for a cross-flow heat exchanger with staggered tube banks. The analysis takes into account six different models of convection heat transfer over the tube banks. In this scenario, the impact of the applied convection model on the value of HTE for the considered heat exchanger was examined. For the considered calculation cases, the value of the HTE parameter is in the range from 0.3 to 0.48 and it decreases with the increase of the flow rate of both air and the flue gases. It has been shown that the results of all four models are very similar, while the other two models bring about either an increase or a decrease of the values of the parameter investigated. It was found that for the analyzed heat exchanger a simplified criterion for the convection heat transfer over tube banks can be used to determine the effectiveness of the heat transfer with the Reynolds number being the only parameter.