This research proposes a novel cooling system to minimize the external rotor type of electric motor temperature by installing fan blades (wafters) on the inner housing of the electric motor. Fan blades (wafters) are made by printing using 3D printer technology and using polylactic acid (PLA) as the material. Wafters are then installed on an in-wheel motor with a power of 1500 W, having 48 poles and 52 slots. The study included thermal simulation and experimental techniques to ascertain how fan blades (wafters) affected the electric motor’s thermal properties. The motor rotated at 500 rpm during the experimental test with no load condition. The temperature of the electric motor is known using an infrared thermal imager. Using Ansys Motor-CAD 15.1 software, thermal modeling employs the lumped circuit model approach. Thermal simulation results show almost the same results as the experimental test results. Applying wafters on the in-wheel motor housing significantly reduces the winding temperature by 3.047 °C or experiences a temperature reduction of 4.34%. Using wafters in the in-wheel motor housing also speeds up the stable state temperature of the electric motor by 9 min compared to in-wheel motors without wafters.
Electric vehicle (EV) proliferation is accelerating, characterized by the rising quantity of electric automobiles on global roadways. The electric machine is a crucial component of an EV, and the heat generated within the motor requires consideration as it impacts performance and longevity. A prevalent form of machine in EV is the in-wheel motor (IWM), which is notable for its compact size. However, it presents more significant cooling challenges. This research offers a new cooling method to cool the IWM. The system consists of wafters mounted on the housing of the IWM. Testing was conducted to determine the effect of wafters on the thermal properties and performance of IWMs. The machine used in this research is a brushless direct current (BLDC) motor featuring an outer rotor configuration and a peak power output of 1.5 kW. Testing was carried out experimentally and by simulation, and the simulation used Ansys Motor-CAD software. The research results show that applying wafers to IWM reduces the temperature of IWM components by up to 13.1%. IWM with wafters results in a torque increase of 0.14%, a power increase of 0.64%, and an efficiency improvement of 0.6% compared to IWM without wafters.