Usage of continuous fibers as a reinforcement would definitely increase the mechanical properties of 3D-printed materials. The result is a continuous fiber-reinforced composite obtained by additive manufacturing that is not limited to prototyping or non-structural applications. Among the available continuous reinforcing fibers, basalt has not been extensively studied in 3D printing. This material is attractive due to its natural origin, good mechanical properties, impact strength, and high chemical and thermal resistance. In this work, a continuous basalt fiber co-extruded composite obtained by fused filament fabrication was characterized both thermally and mechanically, concerning the in-plane tensile properties. The degree of anisotropy of the material was also assessed, both qualitatively and quantitatively. The 3D-printed composite showed longitudinal properties, which were 15 times higher than the pure matrix, thus meeting structural requirements. On the other hand, transverse and shear properties were much lower than longitudinal ones, thus leading to a strongly anisotropic material. This was also confirmed by the anisotropy evaluation that was performed numerically and graphically using an innovative approach. This behavior affects the design of 3D-printed parts; thus, an optimized continuous fiber deposition is necessary for structural applications.
Mechanical recycling of Fused Deposition Modeling 3D printing materials is very attractive for the circular economy. In this paper, the tensile properties of a virgin and a one-time-recycled short carbon fiber reinforced polyamide, coming from 3D printing scrap and failed parts, were evaluated. Anisotropy was taken into account properly by using characterization methods that are typical of composites. Rheological properties were obtained with a parallel plate rheometer in oscillatory mode, and thermal properties were investigated based on thermogravimetric analysis and differential scanning calorimetry. A decrease in the average molecular weight of the recycled material, indicated by the rheological measurements, induced brittleness. Nevertheless, the stiffness and yield strength of the 3D printed parts made with the recycled material were higher than those made with the virgin one. Since this behavior could not be explained based on an increase in crystallinity or a relevant decrease in the void content, a feasible explanation is proposed with an increase of the interlayer and intralayer adhesion quality. In any case, the recycled polyamide filament can be successfully reused in Fused Deposition Modeling 3D printing, even when significant mechanical properties are required, but attention must be paid to a certain decrease in ductility.