Ana Pérez Rodríguez

Dr. Ana Pérez Rodríguez


Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 March 2019 in Energy & Environmental Science
Verified
Journal Article
Open access
PDF file
IGIlario Gelmetti
Ilario Gelmetti
NMNúria F. Montcada
Núria F. Montcada
ARAna Pérez Rodríguez
Ana Pérez Rodríguez
EBEsther Barrena
Esther Barrena
COCarmen Ocal
Carmen Ocal
EPEmilio Palomares-Gil
Emilio Palomares-Gil
In this work, we assess the possible reasons for the differences observed in open circuit voltage (VOC) in mixed cation perovskite solar cells when comparing four different hole transport materials (HTMs), namely TAE-1, TAE-3, TAE-4 and spiro-OMeTAD.

20 February 2018 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
ARAna Pérez Rodríguez
Ana Pérez Rodríguez
ITInés Temiño
Inés Temiño
COCarmen Ocal
Carmen Ocal
Marta Mas-TorrentMarta Mas-Torrent
Marta Mas-Torrent
EBEsther Barrena
Esther Barrena

7 December 2015 in Journal of Materials Chemistry A
Verified
Journal Article
Closed access
PDF file
CWCordula D. Wessendorf
Cordula D. Wessendorf
ARAna Pérez Rodríguez
Ana Pérez Rodríguez
JHJonas Hanisch
Jonas Hanisch
AAAndreas P. Arndt
Andreas P. Arndt
IAIbrahim Ata
Ibrahim Ata
EBEsther Barrena
Esther Barrena
Solution-processed bulk heterojunction solar cells consisting of the previously developed dithienopyrrole containing A–D–A oligothiophenes (A = acceptor, D = donor unit) and [6,6]-phenyl-C71-butyric acid methyl ester (PC71BM) with power conversion efficiency up to 7.1% after solvent vapor annealing (SVA) are demonstrated. The influence of the position of the alkyl side chains attached to the thiophene units on the SVA, and the usage of either PC61BM or PC71BM as acceptor, is investigated in more detail by negative secondary ion mass spectrometry (SIMS), Kelvin probe force microscopy (KPFM), photoluminescence (PL), and grazing-incidence X-ray diffraction spectroscopy (GIWAXS). It was found that besides increased crystallinity and domain sizes, the active layers consisting of two different isomers which we will refer to in the following as isomer 1 or isomer 2 had different compositions after SVA treatment. In the former, a more or less homogeneously-mixed D:A blend was observed, whereas the latter showed a vertical gradient of PCBM in the active layer and much stronger phase segregation on the surface. These findings correlate well with the differences in solar cell performance of both isomers, before and after SVA.

26 November 2019 in Journal of Physics: Energy
Verified
Journal Article
Open access
PDF file
MAMarina Alves
Marina Alves
ARAna Pérez Rodríguez
Ana Pérez Rodríguez
PDPhillip J Dale
Phillip J Dale
CDCésar Domínguez Domínguez
César Domínguez Domínguez
SSSascha Sadewasser
Sascha Sadewasser
Photovoltaic (PV) energy conversion of sunlight into electricity is now a well-established technology and a strong further expansion of PV will be seen in the future to answer the increasing demand for clean and renewable energy. Concentrator PV (CPV) employs optical elements to concentrate sunlight onto small solar cells, offering the possibility of replacing expensive solar cells with more economic optical elements, and higher device power conversion efficiencies. While CPV has mainly been explored for highly efficient single-crystalline and multi-junction solar cells, the combination of thin-film solar cells with the concentration approach opens up new horizons in CPV. Typical fabrication of thin-film solar cells can be modified for efficient, high-throughput and parallel production of organized arrays of micro solar cells. Their combination with microlens arrays promises to deliver micro-concentrator solar modules with a similar form factor to present day flat-panel PV. Such thin-film micro-concentrator PV modules would use significantly less semiconductor solar cell material (reducing the use of critical raw materials) and lead to a higher energy production (by means of concentrated sunlight), with the potential to lead to a lower levelized cost of electricity. This review article gives an overview of the present state-of-the-art in the fabrication of thin-film micro solar cells based on Cu(In,Ga)Se2 absorber materials and introduces optical concentration systems that can be combined to build the future thin-film micro-concentrator PV technology.

30 June 2014 in The Journal of Physical Chemistry C
Verified
Journal Article
Open access
MAMahdieh Aghamohammadi
Mahdieh Aghamohammadi
AFAnton Fernández
Anton Fernández
MSMalte Schmidt
Malte Schmidt
ARAna Pérez Rodríguez
Ana Pérez Rodríguez
AGAlejandro Rodolfo Goñi
Alejandro Rodolfo Goñi
EBEsther Barrena
Esther Barrena
We address the impact of the relative orientation between donor (D) and acceptor (A) molecules at the D/A heterojunction on the exciton dissociation. For this purpose, two-dimensional heterojunctions of diindenoperylene (DIP) and N,N'-dioctyl-3,4,9,10-perylene tetracarboxylicdiimide (PTCDI-C8) deposited onto SiO2/Si are grown, which exemplify two model interfaces with the π-staking direction either perpendicular or parallel to the interface. Aspects related to the morphology of the heterojunctions and charge photogeneration are studied by scanning probe force methods and photoluminescence (PL) spectroscopy. Results from PL spectroscopy indicate that the exciton dissociation is influenced by the different relative molecular orientations of A and D. For the configuration with stronger orbital overlap between A and D at the interface, the exciton dissociation is dominated by recombination from an interfacial charge-transfer state.Financial support by the Spanish Government (projects MAT2010-20020 and NANOSELECT CSD2007-00041) and by the German Research Foundation (DFG) within the priority program SPP1355 is acknowledged.Peer Reviewe

21 September 2017 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
Beatriz R RomeroBeatriz R Romero
Beatriz R Romero
GPGonzalo Del Pozo
Gonzalo Del Pozo
BABelen Arredondo
Belen Arredondo
DMDiego Martín-Martín
Diego Martín-Martín
PGPilar Gordoa
Pilar Gordoa
FGFRANCISCO JAVIER GARCIA-SANCHEZ
FRANCISCO JAVIER GARCIA-SANCHEZ
We explain how to obtain closed-form analytic solutions from the set of equations that describe the three-diode lumped-parameter equivalent circuit model proposed by Mazhari [1] to portray the undesirable S-shape often observed in I-V characteristics of illuminated organic solar cells (OSCs), and occasionally seen in other types of solar cells. This allows quick extraction of the model's parameter values by directly fitting the resulting closed-form solution to the cell's measured I-V data. Such mathematical simplification of the extraction procedure facilitates individually studying the effect of each parameter on the illuminated OSC I-V characteristics, and thus on its power generation capacity. We illustrate application of the direct extraction procedure to measured I-V characteristics of an experimental OSC, which exhibits the illumination intensity-dependent S-shapes. The usefulness of the analytic solution to assess the effect of the model parameters is further corroborated by graphically illustrating the progression of a series of hypothetical synthetic I-V characteristics generated by this analytic solution using gradually changing the parameter values. Analysis of the results, in this case, indicates that activation of the diode that represents recombination is the key factor responsible for the emergence of the illuminated I-V curve's S-shape.