The hole transport layer (HTL) is one of the main factors affecting the efficiency and stability of perovskite solar cells (PSCs). However, obtaining HTLs with the desired properties through current preparation techniques remains a challenge. In the present study, we propose a new method which can be used to achieve a double-layer HTL, by inserting a CuI layer between the perovskite layer and Spiro-OMeTAD layer via a solution spin coating process. The CuI layer deposited on the surface of the perovskite film directly covers the rough perovskite surface, covering the surface defects of the perovskite, while a layer of CuI film avoids the defects caused by Spiro-OMetad pinholes. The double-layer HTLs improve roughness and reduce charge recombination of the Spiro-OMeTAD layer, thereby resulting in superior hole extraction capabilities and faster hole mobility. The CuI/Spiro-OMeTAD double-layer HTLs-based devices were prepared in N2 gloveboxes and obtained an optimized PCE (photoelectric conversion efficiency) of 17.44%. Furthermore, their stability was improved due to the barrier effect of the inorganic CuI layer on the entry of air and moisture into the perovskite layer. The results demonstrate that another deposited CuI film is a promising method for realizing high-performance and air-stable PSCs.
21 March 2016 in The Journal of Physical Chemistry C
All-inorganic CsPbBr3 perovskite solar cells have garnered extensive attention in the photovoltaic domain due to their remarkable environmental stability. Nevertheless, CsPbBr3 prepared using the conventional sequential deposition method suffers from issues such as inferior crystallinity, low phase purity, and poor film morphology. Herein, we propose a pre-crystallization methodology by introducing a minute quantity of CsBr into the PbBr2 precursor solution to generate a small amount of CsPb2Br5 crystals within the PbBr2 film, leading to a porous PbBr2 film with enhanced crystallinity. Under the influence of more pores and CsPb2Br5 crystals as nucleation sites for inducing growth, a CsPbBr3 film with a larger crystal size, lower grain boundary density, stronger crystallinity, and higher phase purity is formed. Compared with untreated devices, photovoltaic devices prepared using the pre-crystallization method achieved a champion photovoltaic conversion efficiency (PCE) of 8.62%. Furthermore, pre-crystallized devices demonstrate higher stability than untreated ones and can still retain 94% of the original PCE after being exposed to air for 1000 h without encapsulating.
High performance silicon combined structure (micropillar with Cu nanoparticles) solar cell has been synthesized from N-type silicon substrates based on the micropillar array. The combined structure solar cell exhibited higher short circuit current rather than the silicon miropillar solar cell, which the parameters of micropillar array are the same. Due to the Cu nanoparticles were decorated on the surface of silicon micropillar array, the photovoltaic properties of cells have been improved. In addition, the optimal efficiency of 11.5% was measured for the combined structure solar cell, which is better than the silicon micropillar cell.
1 January 2018 in Superlattices and Microstructures