Chenyan Ma

Ms. Chenyan Ma


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 January 2025 in Applied Sciences
Verified
Journal Article
Open access
PDF file
YZYuhao Zhu
Yuhao Zhu
YZYuhao Zhu
Yuhao Zhu
YCYong Chen
Yong Chen
CMChenyan Ma
Chenyan Ma
LWLingjun Wang
Lingjun Wang
Bowen YanBowen Yan
Bowen Yan
Wind tunnel test results can be influenced by various factors such as the blockage ratio and scaling ratio. These factors may introduce errors in the experimental outcomes, impacting the accuracy and reliability of the data obtained. This study quantitatively assesses consistency and identifies uncertainty sources to enhance result uniformity across various wind tunnel laboratories. This study conducted a systematic comparison between different wind tunnels in terms of rigid model pressure measurement wind tunnel experiments on the same Commonwealth Advisory Aeronautical Research Council (CAARC) standard tall building model. The study analyzes and discusses the results of mean and root-mean-square (RMS) wind pressure coefficients, peak factors, extreme wind pressure coefficients, probability density distributions, and base overturning force coefficients. The results indicated that in the open-circuit wind tunnel laboratory, the mean wind pressure coefficient is underestimated in the positive pressure region and overestimated in the negative pressure region. This is due to the static pressure which significantly decreases the streamwise direction within the test section, and the difference in static pressure is logarithmically proportional to the mean wind speed. Additionally, dynamic pressure is uniformly distributed along the test section axis. The inaccurate measurement of static pressure leads to these results. To address this issue, an indirect measurement method was employed to correct the static pressure results and reduce the error in the mean wind pressure coefficient to within 10%. Furthermore, differences in turbulence integral scale result in an error of up to 16% in the RMS wind pressure coefficient. Therefore, when conducting rigid model pressure measurement wind tunnel experiments, especially in open-circuit wind tunnel laboratories, careful consideration should be given to the influence of static pressure drop and integral length scale of turbulence.

7 April 2023 in Atmosphere
Verified
Journal Article
Open access
PDF file
Bowen YanBowen Yan
Bowen Yan
YHYini He
Yini He
CMChenyan Ma
Chenyan Ma
XCXu Cheng
Xu Cheng
Downbursts occur frequently in mountainous regions, such as the southwest of China, and causing extensive damage to engineering structures. While some researchers have developed semiempirical models for the speedup effect, most are based on the wind field in the boundary layer over the hill, and there is a lack of semiempirical models for the downburst wind field over the hill. This study employs three RANS (Reynolds Average Navier-Stokes) turbulence models to numerically simulate the downburst wind field over a quadratic curved hill. The realizable k-ε model is selected as the optimal model for the subsequent numerical simulations based on comparison with wind tunnel test results. Then, a semiempirical model of the speedup effect of the downburst wind field over the hill is constructed by numerically simulating the downburst wind field over the hill with different radial locations and different slopes. Finally, the constructed semiempirical model is validated and demonstrates good accuracy.

14 June 2023 in Applied Sciences
Verified
Journal Article
Open access
PDF file
Bowen YanBowen Yan
Bowen Yan
RSRuifang Shen
Ruifang Shen
CMChenyan Ma
Chenyan Ma
XCXu Cheng
Xu Cheng
Guoqing  HuangGuoqing Huang
Guoqing Huang
ZZZhigang Zhang
Zhigang Zhang
With the rapid development of computational fluid dynamics (CFD) technology, it has been widely used to study the wind field characteristics of downbursts in mountainous areas. However, there is little guidance on the selection of different turbulence models for simulating downburst wind fields over hills using CFD, and few comparative studies have been conducted. This paper used nine turbulence models to simulate the wind field of a downburst over a 3D quadratic ideal hill. The simulated values of average and transient winds were compared with wind tunnel test data, and the flow characteristics at different moments under a downburst were analyzed. The flow characteristics in the wake region of the downburst over the hill are also quantitatively analyzed using the proper orthogonal decomposition (POD) method. The results show that approximately 85% of the results from the LES and REA models fall within a 30% error range, so the large eddy simulation (LES) model and the realizable k-ε model (REA) are more accurate in simulating the mean wind field, and the transient wind field simulated by the LES model is also in good agreement with the experimental data. In addition, this paper reveals the evolution mechanism of the transient wind field structure over a hill model under a downburst and finds that the first-order mode obtained by POD may be related to the acceleration effect on the hilltop.

6 January 2026 in Sustainability
Verified
Journal Article
Open access
PDF file
HYHui Yuan
Hui Yuan
ZLZhumao Lu
Zhumao Lu
SXSiqing Xu
Siqing Xu
WZWei Zhang
Wei Zhang
YZYuhao Zhu
Yuhao Zhu
YWYu Wang
Yu Wang
Downbursts generate strong and transient near-surface winds that significantly influence wind flows over complex terrains. In this study, two downburst models—the impinging jet model representing the near-field region and the wall jet model representing the fully developed outflow—were experimentally investigated. The study examined the characteristics of mountain wind fields within the fully developed region, considering variations in mountain height, slope, shape, and radial position. Results show that mountain height and shape exert only minor influences on the mountain speed-up ratio, whereas slope and radial position play dominant roles: the acceleration ratio decreases with increasing radial distance and with steeper slopes. The near-surface flow is mainly affected within a vertical range of approximately 1.5 times the mountain height and a radial distance of about four times the height. By explicitly comparing the two models, this study provides the quantitative experimental relationship linking the vertical position of maximum horizontal velocity between impinging jet and wall jet flows. The comparison of mountain wind fields under equivalent positions demonstrated consistent speed-up ratios, confirming that the wall jet model can effectively reproduce the fully developed stage of downburst winds over mountainous terrain. Thus, this work offers new experimental evidence and a validated modeling framework for studying mountain wind effects under downburst conditions.