This study employs CiteSpace 6.3 R1 software to conduct a quantitative analysis of 645 cavitation-related centrifugal pump publications from the Web of Science Core Collection database (2007–2025) using bibliometric methods. The analysis encompasses publication volume statistics, keyword co-occurrence analysis, and keyword clustering. The results indicate that research on centrifugal pump cavitation is currently in a phase of rapid development. The annual number of publications related to centrifugal pump cavitation shows an overall fluctuating upward trend, with Jiangsu University emerging as the leading research institution. The research hotspots include fault diagnosis, impeller design, numerical simulation, and validation, forming four major developmental pathways. Research on cavitation in centrifugal pumps has gradually shifted its focus from numerical simulation to practical engineering issues such as pressure pulsation and cavitation, with hot topics evolving at an accelerated pace. Future efforts must address challenges like cavitation monitoring and high-precision simulation to comprehensively enhance the anti-cavitation performance and operational reliability of centrifugal pumps.
In this work, electrostatic minimum quantity lubrication (EMQL) has been applied in grinding. When the droplets were charged, it could promote penetrability in the processing area. The electric field formed between the charged droplets and the surface of Cr12 die steel could affect the hardness of the workpiece surface. The grinding mechanism of EMQL has been revealed under different charging voltage by analyzing the wetting angle of droplets and the hardness of Cr12 surface. The reduction of grinding force (11.5% to 49%), surface roughness (10% to 22.1%), and the increase in grinding ratio (1.9% to 27.3%) and surface quality of EMQL under various charging voltages were studied. The results showed that the wetting angle decreased when the droplets were charged. Compared to MQL, the charged lubricant droplets with better penetrability are easier to penetrate and spread on the contact surface between the grinding wheel and the workpiece, thereby improving the lubrication of the friction interface and obtaining better grinding performance. Moreover, we also found that the positively charged EMQL not only effectively improves the penetrability of droplets but reduces the hardness of the Cr12 surface. Thus, the grinding performances under positively charged EMQL are always better than these under negatively charged when grinding Cr12.
The process of penetration of lubricants into the frictional interface in steel machining such as turning and milling is not well revealed, which has thus compromised their machining performance. In this paper, the penetration characteristics of deionized water (Di-water) containing different electro-osmosis additives were investigated using a steel-on-steel friction pair. The worn surface lubricated with water solutions were examined using advanced surface analysis techniques. The results indicate that water lubricants were electrically driven to the frictional interface for lubrication. The addition of positive electro-osmosis additives helped promote the penetration of water solutions, thus resulting in the formation of a thick lubricating film of iron oxide at the sliding surface. This reduced abrasion damage significantly, therefore producing a lower coefficient of friction (COF) and wear loss in comparison with pure water.
The cutting process is accompanied by complex electrical phenomena, which are particularly evident in narrow cutting clearances. To further explore the laws of electrical phenomena in the capillary of the cutting zone, this paper uses a Faraday collector with an external bias electric field to investigate the electrical phenomena in the narrow slit of the cutting zone under different cutting parameters and when different tool and workpiece materials are combined. The results show that there is a stable and continuous electrical phenomenon in the cutting contact area, and the emission intensity of charged particles when cutting insulating materials is significantly higher than that of metals. The emission intensity of negative ions is higher than that of positive ions. The electrical and mechanical properties of materials have a significant impact on the electrical phenomena in the cutting zone. In addition, it was found that there is a linear relationship between the electrical phenomena in the cutting zone and the cutting parameters. Finally, based on the morphology of the capillaries in the cutting zone, the self-excited electric field intensity generated in it during the cutting process was estimated.