Adriana Vargas-Nordcbeck

Dr. Adriana Vargas-Nordcbeck


Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 April 2012 in Road Materials and Pavement Design
Verified
Journal Article
Closed access
AVAdriana Vargas-Nordcbeck
Adriana Vargas-Nordcbeck
DTDavid H. Timm
David H. Timm
The objectives of this study were to perform a rutting characterization of warm mix asphalt (WMA) mixtures and mixtures containing high reclaimed asphalt pavement (RAP) and to determine the effects of production temperature and material type on permanent deformation. This study was based on data from the National Center for Asphalt Technology (NCAT) Test Track Phase IV research cycle and included a control section, two WMA sections and two sections with 50% RAP. Field measurements indicated that high RAP mixes had higher moduli and experienced lower vertical pressures than virgin mixes. The use of WMA technologies tended to increase permanent deformation while the addition of high RAP contents resulted in less rutting. Laboratory tests on recovered binders showed increased binder stiffness for high RAP mixes and no significant effect for virgin WMA mixes. Mixture tests of laboratory compacted samples did not reflect the observed field performance accurately.

28 January 2020 in Transportation Research Record: Journal of the Transportation Research Board
Verified
Journal Article
Closed access
PDF file
AVAdriana Vargas-Nordcbeck
Adriana Vargas-Nordcbeck
FJFarhang Jalali
Farhang Jalali
Crack sealing and filling is used as a pavement preservation treatment to prevent water infiltration and loss of load-carrying capacity, hence extending the life of the pavement. This study used field performance data of test sections from the Pavement Preservation Group (PG) Study being conducted in part by the National Center for Asphalt Technology (NCAT). Data from test sections located in a low traffic volume road with a hot, wet, no-freeze climate collected over a period of more than 6 years were used to evaluate the effect of crack sealing and filling, either as a stand-alone treatment or in combination with other surface treatments. A semi-parametric survival analysis was performed to determine the difference in median time to failure (MTTF) for sections with and without crack sealing. The results showed that when used as a stand-alone treatment on a pavement in “good” condition, the life-extending benefit from crack sealing/filling could not be calculated for the selected analysis period because the MTTF would not be reached within 10 years. The estimated benefit for pavements in “fair” and “poor” condition ranged from 1.1 to 7.3 years, depending on pretreatment condition and travel lane. If used in combination with a chip seal, the additional life-extending benefit for a pavement in “good” condition is approximately 2 years, and is slightly decreased to approximately 1.5 years if the pavement is in “fair” to “poor” category. Test sections continue to be monitored as part of a broader long-term study.

1 July 2017 in International Journal of Pavement Research and Technology
Verified
Journal Article
Open access
FLFabricio Leiva
Fabricio Leiva
AVAdriana Vargas-Nordcbeck
Adriana Vargas-Nordcbeck
JAJosé Pablo Aguiar-Moya
José Pablo Aguiar-Moya

12 April 2022 in Transportation Research Record: Journal of the Transportation Research Board
Verified
Journal Article
Closed access
AVAdriana Vargas-Nordcbeck
Adriana Vargas-Nordcbeck
ABAnthony Brenes-Calderón
Anthony Brenes-Calderón
Mill and thin asphalt overlays are a popular preservation treatment for asphalt and composite pavements owing to their ability to address a variety of distresses. Their effectiveness depends on different factors such as traffic, climate, and condition of the pavement at the time of treatment, with typical treatment lives ranging from 5 to 12 years. In cold regions, performance in relation to roughness is of particular interest, as factors like frost action and thermal cracking tend to accelerate roughness progression. The objective of this study was to evaluate the effect of thin asphalt overlays on pavement roughness in cold climate locations using a set of field performance data from the Pavement Preservation Group Study, a broader research study conducted by the National Center for Asphalt Technology and the Minnesota Department of Transportation’s Road Research Facility. The findings indicated that treatment application resulted in both short- and long-term benefits. Following construction, a performance jump was obtained, which was greater for pavement sections with higher International Roughness Index (IRI) IRIpre values. This can be interpreted as rougher sections benefiting more in the short term than smoother sections, where the IRI is already low. Conversely, pavements with lower roughness at the time of treatment obtained greater life-extending benefits. This is interpreted as smoother pavements obtaining a greater benefit over time, and reinforces the concept of preserving pavements while in good condition to maximize pavement life. The magnitude of the benefits was also dependent on the type of milling machine used.

1 June 2022 in Transportation Research Record: Journal of the Transportation Research Board
Verified
Journal Article
Closed access
DADavid Allain
David Allain
BBBenjamin F. Bowers
Benjamin F. Bowers
AVAdriana Vargas-Nordcbeck
Adriana Vargas-Nordcbeck
TLTiana Lynn
Tiana Lynn
In 2019 a series of test sections were constructed on 70th Street in Albertville/Otsego, MN. The existing roadway was badly deteriorated with an international roughness index value above 300 in./mi, which places it in a “poor” performance category. A combination of treatments including cold in-place recycling (CIR), cold central plant recycling (CCPR), and full depth reclamation (FDR) stabilized with foamed or emulsified asphalt were used to evaluate performance in cold regions. Sections including a typical hot mix asphalt (HMA) mill and fill were also evaluated. All sections contained a 1-in. HMA thinlay as the wearing surface. This paper presents the laboratory testing data for the mixtures, including application of HMA tests not typically applied to CIR, CCPR, and FDR, the field performance to date, and a new approach to connecting laboratory data to field performance.

11 March 2011
Verified
Conference Paper
Closed access
AVAdriana Vargas-Nordcbeck
Adriana Vargas-Nordcbeck
DTDavid H. Timm
David H. Timm
Pavement temperature is an important factor of the urban heat island (UHI) effect and it also plays an important role in pavement design. The objective of this study was to compare the pavement temperatures and heat absorbed for nine different pavement sections placed during construction of Phase IV at the National Center for Asphalt Technology (NCAT) Test Track. Temperature probes were installed in each section to measure temperatures at the top, middle and bottom of the asphalt concrete (AC) and three inches into the underlying aggregate base layer. Temperatures were recorded on an hourly basis over a one month period from August to September 2009. Results indicated that an increase in density may also increase pavement temperatures and stored energy. Additionally, changing components or the structure of the asphalt mixture may change its thermophysical properties as well as the amount of energy the pavement is able to store.