Tunnel fires often lead to vehicles being trapped inside, causing the “blocking effect”. In this work, fire plume behavior and the maximum ceiling temperature rise in a curved tunnel with blocked vehicles under longitudinal ventilation conditions are studied numerically. The results show that, in curved tunnels, the fire plume in the quasi-stable state exhibits dynamic deflections between the concave and convex walls of the tunnel, so the location of high-temperature zones varies accordingly. The flow field structure in the near field of the blockage and the fire source is complex but can be decoupled into four characteristic sub-structures, i.e., the free shear layer, recirculation I above the vehicle blockage, recirculation II behind the downstream of the blockage, and recirculation III at the top of the tunnel. Recirculation I and II pull the fire plume upstream, while free shear layer and recirculation III pull the flame downstream. The final plume deflection direction depends on the relative strengths of these two pulling forces. As the longitudinal air velocity increases, the plume deflection direction changes from downstream to upstream of the fire source, forming the “downstream tilt—touch the ceiling above the fire source—upstream tilt” mode, resulting in the maximum ceiling temperature rise fluctuating in a decreasing-increasing-decreasing trend. Moreover, the higher the blocking ratio, the lower the critical air velocity required to induce the transition of the plume deflection directions, e.g., a critical wind speed of 3 m/s for a blockage ratio of 0.46 and a critical wind speed of 1 m/s for a blockage ratio of 0.62. Finally, a semi-empirical equation of the maximum ceiling temperature rise in curved tunnels, considering both longitudinal wind and the vehicle blocking ratio, is proposed and validated. This work highlights the multi-dimensional and non-stable plume behavior pattern in a complex tunnel fire scenario, thus providing a deeper understanding to improve the classical tunnel fire dynamic system.
Motor vehicle exhaust in urban tunnels can cause nitric oxide (NO) to accumulate, severely degrading air quality both inside the tunnel and in the surrounding environment. Photocatalytic technology is an efficient, secondary-pollution-free approach with clear potential for treating tunnel exhaust; however, parametric analyses for practical tunnel engineering applications remain limited. Using computational fluid dynamics (CFD), this study developed a numerical model to simulate photocatalytic NO degradation in a congested tunnel and examined how the surface reaction rate, coating extent, and longitudinal coated section affect NO reduction performance. The results show that NO reduction efficiency increased with the surface reaction rate; however, once the surface reaction rate constant exceeded 2.11 × 10−4 m/s, further gains diminished and the efficiency approached a plateau due to mass-transfer limitations. With respect to the coating extent, full four-wall coating (sidewalls, ceiling, and road surface) provided the best performance, followed by three-wall coating (excluding the ceiling). Moreover, because the road surface lies in a region of high pollutant concentration and low air velocity, coating on the road surface achieved a markedly stronger reduction effect than coating on the sidewalls or the ceiling. In the simulated 500 m tunnel, the downstream coated section achieved a markedly higher NO reduction efficiency in the ambient environment outside the tunnel (5.9%) than the upstream coated section (1.0%), approaching that of the full-length (500 m) coated section (6.6%). Therefore, in practical engineering applications, priority should be given to coating strategies targeting the downstream section and the road surface in order to balance NO reduction performance and economic cost. Such a strategy is beneficial not only for improving tunnel air quality, but also for promoting sustainable pavement and tunnel-surface engineering by reducing unnecessary coating area and enabling a more resource-efficient and cost-effective use of photocatalytic materials. These findings provide theoretical and methodological support for the sustainable design and application of photocatalytic coating systems in urban tunnels.