Measurements were made on the mean flowfield created through the interaction between a two-dimensional flat plate turbulent boundary layer on a flat plate and an inclined jet. The jet was generated by a nozzle of rectangular exit and was pitched and skewed to the oncoming flow. A total of three pitch angles and two jet velocity ratios were tested. The measurements were performed with a three-component laser Doppler anemometer system in a low speed wind tunnel. The dominant feature of the flow physics is a single longitudinal vortex produced as a result of jet/boundary layer interaction, with additional induced secondary features in the near-wall area in the spanwise direction. A salient feature of the flow is its maximum vorticity position which is located underneath the center of the vortex. Within the measured flow parameter range, the vortex development differs also from that of a round jet, differences in the velocity distribution are observed. The study provides contributions to flow physics.
1 January 2019 in Journal of Zhejiang University-SCIENCE A
Tunnel fires often lead to vehicles being trapped inside, causing the “blocking effect”. In this work, fire plume behavior and the maximum ceiling temperature rise in a curved tunnel with blocked vehicles under longitudinal ventilation conditions are studied numerically. The results show that, in curved tunnels, the fire plume in the quasi-stable state exhibits dynamic deflections between the concave and convex walls of the tunnel, so the location of high-temperature zones varies accordingly. The flow field structure in the near field of the blockage and the fire source is complex but can be decoupled into four characteristic sub-structures, i.e., the free shear layer, recirculation I above the vehicle blockage, recirculation II behind the downstream of the blockage, and recirculation III at the top of the tunnel. Recirculation I and II pull the fire plume upstream, while free shear layer and recirculation III pull the flame downstream. The final plume deflection direction depends on the relative strengths of these two pulling forces. As the longitudinal air velocity increases, the plume deflection direction changes from downstream to upstream of the fire source, forming the “downstream tilt—touch the ceiling above the fire source—upstream tilt” mode, resulting in the maximum ceiling temperature rise fluctuating in a decreasing-increasing-decreasing trend. Moreover, the higher the blocking ratio, the lower the critical air velocity required to induce the transition of the plume deflection directions, e.g., a critical wind speed of 3 m/s for a blockage ratio of 0.46 and a critical wind speed of 1 m/s for a blockage ratio of 0.62. Finally, a semi-empirical equation of the maximum ceiling temperature rise in curved tunnels, considering both longitudinal wind and the vehicle blocking ratio, is proposed and validated. This work highlights the multi-dimensional and non-stable plume behavior pattern in a complex tunnel fire scenario, thus providing a deeper understanding to improve the classical tunnel fire dynamic system.
In longitudinal ventilation, circulating air is formed in portals for closely spaced twin tunnels, which causes mixing between the polluted air exhausted from one tunnel and the fresh air flow of another tunnel, thus leading to the rising costs of ventilation system construction and operation. In this study, for the closely spaced tunnel with staggered inlet and outlet, the computational fluid dynamics (CFD) numerical simulation method was adopted to reveal flow characteristics of the circulating air as well as variation rules of the circulating air mixing ratio φc with tunnel structure and operation parameters. Results show that both reducing inlet air velocity and increasing outlet air velocity and lateral distance can reduce the impact of the negative-pressure zone at the tunnel entrance on the jet flow structure at the tunnel exit, thus weakening the circulating air. When the inlet is placed behind or aligned with the outlet (staggered distance ∆l ≤ 0), φc will increase linearly along with the increase of staggered distance; when the inlet is placed before the outlet (∆l > 0), φc will first increase and then decrease with the increase of staggered distance. An expression to predict circulating air mixing ratio was created by sections. The predictions show a good correlation with the measurements and indicate that the front slope gradient of the tunnel portal is also one of the factors affecting the circulating air mixing ratio.
18 June 2025 in Journal of Zhejiang University-SCIENCE A
The construction of bifurcated tunnels is essential to advancing urban infrastructure systems, as they conserve land, reduce carbon emissions, and optimize