By studying the minority carrier lifetime in recently manufactured commercially available n‐ and p‐type float‐zone (FZ) silicon from five leading suppliers, we observe a very large reduction in the bulk lifetime when FZ silicon is heat‐treated in the range 450–700 °C. Photoluminescence imaging of these samples at the wafer scale revealed concentric circular patterns, with higher recombination occurring in the centre, and far less around the periphery. Deep level transient spectroscopy measurements indicate the presence of recombination active defects, including a dominant center with an energy level at ∼Ev + 0.5 eV. Upon annealing FZ silicon at temperatures >1000 °C in oxygen, the lifetime is completely recovered, whereby the defects vanish and do not reappear upon subsequent annealing at 500 °C. We conclude that the heat‐treatments at >1000 °C result in total annihilation of the recombination active defects. Without such high temperature treatments, the minority carrier lifetime in FZ silicon is unstable and will affect the development of high efficiency (>24%) solar cells and surface passivation studies.
Accurate measurements of the bulk minority carrier lifetime in high‐quality silicon materials is challenging due to the influence of surface recombination. Conventional surface passivation processes such as thermal oxidation or dielectric deposition often modify the bulk lifetime significantly before measurement. Temporary surface passivation processes at room or very low temperatures enable a more accurate measurement of the true bulk lifetime, as they limit thermal reconfiguration of bulk defects and minimize bulk hydrogenation. In this article we review the state‐of‐the‐art for temporary passivation schemes, including liquid immersion passivation based upon acids, halogen‐alcohols and benzyl‐alcohols, and thin film passivation usually based on organic substances. We highlight how exceptional surface passivation (surface recombination velocity below 1 cm s−1) can be achieved by some types of temporary passivation. From an extensive review of available data in the literature, we find p‐type silicon can be best passivated by hydrofluoric acid containing solutions, with superacid‐based thin films showing a slight superiority in the n‐type case. We review the practical considerations associated with temporary passivation, including sample cleaning, passivation activation, and stability. We highlight examples of how temporary passivation can assist in the development of improved silicon materials for photovoltaic applications, and provide an outlook for the future of the field.
Czochralski‐grown gallium‐doped silicon wafers are now a mainstream substrate for commercial passivated emitter and rear cell (PERC) devices and allow retention of established processes while offering enhanced cell stability. We have assessed the carrier lifetime potential of such Czochralski‐grown wafers in dependence of resistivity, finding effective lifetimes well into the millisecond region without any gettering or hydrogenation processing, thus demonstrating one advantage over boron‐doped silicon. Second, the stability of gallium‐doped PERC cells are monitored under illumination (>3000 h in some cases) and anomalous behavior is detected. While some cells are stable, others exhibit a degradation then recovery, reminiscent of light and elevated temperature‐induced degradation (LeTID) observed in other silicon materials. Surprisingly, cells from one ingot exhibit LeTID‐like behavior when annealed at 300 °C but near stability when not annealed, but, for another ingot, the opposite is observed. Moreover, a stabilization process typically used to mitigate boron–oxygen degradation does not influence any cells that are studied. Secondary‐ion mass spectrometry of the PERC cells reveals significant concentrations of unintentionally incorporated boron in some cases. Nevertheless, even in the absence of mitigating light‐induced degradation, Ga‐doped silicon is still more stable than unstabilized B‐doped silicon under illumination.
Minimizing carrier recombination at interfaces is of extreme importance in the development of high-efficiency photovoltaic devices and for bulk material characterization. Here, we investigate a temporary room temperature superacid-based passivation scheme, which provides surface recombination velocities below 1 cm/s, thus placing our passivation scheme amongst state-of-the-art dielectric films. Application of the technique to high-quality float-zone silicon allows the currently accepted intrinsic carrier lifetime limit to be reached and calls its current parameterization into doubt for 1 Ω·cm n-type wafers. The passivation also enables lifetimes up to 65 ms to be measured in high-resistivity Czochralski silicon, which, to our knowledge, is the highest ever measured in Czochralski-grown material. The passivation strategies developed in this work will help diagnose bulk lifetime degradation under solar cell processing conditions and also help quantify the electronic quality of new passivation schemes.