TiO2-SiO2-Fe2O3 heterojunction using the ceramic technique was used in this study to investigate its effectiveness as a photocatalyst for Rhodamine B (RhB) dye degradation. Structural, optical, and morphological characterizations of the synthesized materials were carried out by X-ray diffraction (XRD), photoluminescence analysis (PL), scanning electron microscopy (SEM-EDS), and diffuse reflectance spectroscopy (DRS) to calculate the gap energy. In addition, a degradation rate of around 97% was obtained at a pH of 8, an initial RhB concentration of 10 mg·L−1, a TS-1F semiconductor dosage of 1 g·L−1, and a reaction time of 210 min. The ability of photocatalysis to degrade RhB at different ratios, pH, and with/without H2O2 in aqueous media was evaluated under UV light, visible light (250 W), and sunlight. When it comes to the degradation of RhB under visible light (250 W) and sunlight, respectively, the influence of the n–p junction showed promising results for the degradation of RhB. In contrast, there was no discernible photocatalytic activity under UV light, which proves that the absorbance switched from UV to visible, demonstrating the decrease in the band gap energy. Additionally, an analysis of the procedure’s cost-effectiveness and reusability through an economic study revealed that the synthesized material was interesting in terms of both cost and sustainability.
The green biosynthesis of zinc oxide nanoparticles (GBS ZnO NPs) using Ziziphus jujuba leaves extract assisted by ultrasonic irradiation was reported in this research work. The green biosynthesized ZnO NPs were characterized using different techniques and the results revealed the synthesis of hexagonal wurtzite crystal of GBS ZnO nanoparticles; per the XRD measurement, with average practice size of 90 ± 10 nm; based on both SEM and TEM images, and with specific surface area of 14.23 m2/g; per the nitrogen gas adsorption/desorption isotherms. The antibacterial activity of the prepared GBS ZnO NPs was explored against S. aureus and E. coli bacteria using different evaluation methods; disc diffusion, column (filter), and aqueous solution, and the results showed the effective antibacterial activities against S. aureus and E. coli bacteria, as the inhibition zones were 15 mm and 11 mm for the E. coli and S. aureus, respectively. Moreover, the anticancer activity of the green biosynthesized ZnO NPs was evaluated on two different cancer cells; human colon cancer cell lines (HCT-116) and the human liver cancer (HepG2) cells, and the experiments showed that GBS ZnO NPs had an outstanding cytotoxic effect on both cancer cell lines, as well as dose-dependent behavior, as the viability of the cancer cells decreased by using GBS ZnO NPs at concentrations of 10 and 20 µg/mL. Cell lines (HCT-116) and the human liver cancer (HepG2) cells, and the experiments showed that GBS ZnO NPs had an outstanding cytotoxic effect on both cancer cell lines, as the GBS ZnO NPs enhanced the cytotoxicity mechanism by generating ROS as the nanoparticles interact with cells, lower its cellular defense mechanism, and accordingly cause apoptosis to the cell.
This study aims to investigate the potential of designed 2,3-dihydro-1,3,4-thiadiazole derivatives as anti-proliferative agents targeting VEGFR-2, utilizing a multidimensional approach combining in vitro and in silico analyses.
Over time, nanoparticles’ chemistry has shown exceptional ability to solve a wide range of problems in various fields, including the control of microbiological air quality in buildings. Herein, magnesium ferrite (MgFe2O4) was synthesized using coprecipitation, then characterized using X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), Brunauer–Emmett–Teller (BET), scanning electron microscopy (SEM), Transmission Electron Microscopy (TEM) and photoelectron spectroscopy (XPS). MgFe2O4 nanoparticles were then assessed for their ability to inhibit Escherichia coli ATCC 8739 growth and airborne bacterial viability in a laboratory atmosphere through a direct air filtration system. The material showed strong inhibitory activity against E. coli by eliminating practically all viable cells in the tested suspensions after 1 h contact time in the presence of light. Finally, the prepared air filtration setup revealed that passing air bacteria through non-woven fabric filters impregnated with MgFe2O4 effectively eliminates them. Thus, only 1 colony-forming unit (CFU) was obtained from 36 L of filtered air, while a control filter (without MgFe2O4) allowed the passage of 2.6 × 105 CFU to the liquid medium. The obtained results initiate potential applications of MgFe2O4 nanoparticles in controlling microbiological indoor air quality (IAQ), especially in healthcare facilities where microbial resistance to antibiotics is the most notable, individuals are the most exposed, and contamination risks are the highest.
This study integrates molecular dynamics (MD) simulations and density functional theory (DFT) computations to elucidate the unique adsorption characteristics of phenol and para-chlorophenol onto sepiolite by examining structural deformation, electronic properties, and adsorption energetics. The hydroxyl group (-OH) of phenol mainly determines its adsorption process since it has a quite negative Mulliken charge (−0.428) and significant electrophilic reactivity (fi+ = 0.090), therefore enabling strong hydrogen bonding with the silanol (-SiOH) groups of sepiolite. By π-π interactions with the electron-rich siloxane (-Si-O-Si-) surfaces, the aromatic carbons in phenol improve stability. The close molecular structure allows minimum deformation energy (Edef = 94.18 kcal/mol), hence optimizing alignment with the sepiolite surface. The much negative adsorption energy (Eads = −349.26 kcal/mol) of phenol supports its further thermodynamic stability. Conversely, because of its copious chlorine (-Cl) component, para-chlorophenol runs against steric and electrical obstacles. The virtually neutral Mulliken charge (−0.020) limits electrostatic interactions even if the chlorine atom shows great electrophilicity (fi+ = 0.278). Chlorine’s electron-withdrawing action lowers the hydroxyl group’s (fi+ = 0.077) reactivity, hence lowering hydrogen bonding. Moreover, para-chlorophenol shows strong deformation energy (Edef = 102.33 kcal/mol), which causes poor alignment and less access to high-affinity sites. With less negative than phenol, the adsorption energy for para-chlorophenol (Eads = −317.53 kcal/mol) indicates its reduced thermodynamic affinity. Although more evident in para-chlorophenol because of the polarizable chlorine atom, van der Waals interactions do not balance its steric hindrance and reduced electrostatic interactions. With a maximum Qmax = 0.78 mmol/g, isotherm models confirm the remarkable adsorption capability of phenol in contrast to Qmax = 0.66 mmol/g for para-chlorophenol. By hydrogen bonding and π-cation interactions, phenol builds a dense and structured adsorption layer, and para-chlorophenol shows a chaotic organization with reduced site use. Supported by computational approaches and experimental validation, the results provide a comprehensive knowledge of adsorption mechanisms and provide a basis for the design of adsorbents catered for particular organic pollutants.