The present paper is intended to show the close interrelationship between non-linear models of solids, produced with additive manufacturing, and models of solids with distributed defects. The common feature of these models is the incompatibility of local deformations. Meanwhile, in contrast with the conventional statement of the problems for solids with defects, the distribution for incompatible local deformations in additively created deformable body is not known a priori, and can be found from the solution of the specific evolutionary problem. The statement of the problem is related to the mechanical and physical peculiarities of the additive process. The specific character of incompatible deformations, evolved in additive manufactured solids, could be completely characterized within a differential-geometric approach by specific affine connection. This approach results in a global definition of the unstressed reference shape in non-Euclidean space. The paper is focused on such a formalism. One more common factor is the dataset which yields a full description of the response of a hyperelastic solid with distributed defects and a similar dataset for the additively manufactured one. In both cases, one can define a triple: elastic potential, gauged at stress-free state, and reference shape, and some specific field of incompatible relaxing distortion, related to the given stressed shape. Optionally, the last element of the triple may be replaced by some geometrical characteristics of the non-Euclidean reference shape, such as torsion, curvature, or, equivalently, as the density of defects. All the mentioned conformities are illustrated in the paper with a non-linear problem for a hyperelastic hollow ball.
In this paper, the experimental methodology for the single-crystal circular plate deformation measurement and subsequent procedure for the quantitation of its mechanical properties are developed. The procedure is based on a new numerical-analytical solution of non-linear boundary-value problem for finite deformations of a circular anisotropic plate. Using the developed method, a study of the deformation of single-crystal circular plates formed on the basis of a silicon-on-insulator structure was carried out. The values of residual stresses are determined and it is shown that the presence of these stresses increases the flexural rigidity of the plate by several times.
The results of studies on the fabrication and optimization of the configuration of magnetic-field sensors based on anisotropic magnetoresistive thin-film structures are described. Magnetic-field...
The main problems of the gas flow meters are the improvement of the sensitivity and velocity range. In this paper thermoresistive membrane gas flow sensor is considered. The sensor is based on the calorimetric principle of operation and developed for the thermal gas flow meters. Special streamlined body was used to improve sensor’s characteristics. It is shown that streamlined body raises sensitivity by 2 times and improves velocity range of the sensor.
1 July 2016 in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
The energy dependence of the electron inelastic mean free path, λ(), in silicon oxide and silicon nitride is experimentally determined via Auger electron spectroscopy according to Auger signal attenuation with varying film thickness. Silicon-oxide- and silicon-nitride films are formed on different metal substrates by means of plasma-enhanced chemical vapor deposition. Analysis of the results and their comparison with theoretical data indicate that, in the chosen material, variations in the electron mean free path versus their energy are estimated more reliably by means of experiments than through the use of universal theoretical curves. It appears that the results obtained in this work can help in the more accurate determination of the width and location of interfaces in multilayer structures.