In this study, a significant number of experimental tests to PEM fuel cells were conducted to investigate the effect of gas flow fields on fuel cell performance. Graphite plates with various flow field or flow channel designs, from literature survey and also novel designs by the authors, were used for the PEM fuel cell assembly. The fabricated fuel cells all have an effective membrane area of 23.5 cm2. The results showed that the serpentine flow channel design is still favorable, giving the best single fuel cell performance amongst all the studied flow channel designs. A novel symmetric serpentine flow field was proposed for relatively large size fuel cell application. Four fuel cell stacks each including four cells were assembled using different designs of serpentine flow channels. The output power performances of fuel cell stacks were compared and the novel symmetric serpentine flow field design is recommended for its very good performance.
The present paper shows an entropy generation analysis for a PEM fuel cell. The numerical model takes into account the complete solution of Navier-Stokes, energy conservation, species conservation and two potential fields for the transport of electrons and protons in the collectors and membrane respectively. The entropy generation equation is added to the governing equations using the solutions provided from the energy, momentum, species and potential flow equations. The entropy generation analysis reveals the locations where the main losses (irreversibilities) are produced. This in consequence shows the best flow field to minimize the entropy production. A new parameter is proposed in this work that will compare the entropy production due to the mass flow to the total entropy production.
A parametric study was conducted in order to reduce the pressure drop and to improve the uniformity of flow distribution in a symmetric flow distributor. A CFD model was employed to simulate the flow behavior by solving the Navier-Stokes equations in a complete 3D model. The present work is a complete parametric study of a base model, reported in previous studies, but keeping the same flow pattern. To improve the performance of the base design, three known successive parametric ratios, as functions of the hydraulic diameters of the channels, were tested in order to study the advantages and disadvantages of each one in terms of two dimensionless parameters that measure the uniformity of flow distribution. A remarkable improvement in the performance of the base model was achieved by modifying the width ratio of the channels. The present work is a contribution to the study of flow distributors to be used as heat exchangers, PEMFC flow channels and other flow devices.