In this study, a significant number of experimental tests to PEM fuel cells were conducted to investigate the effect of gas flow fields on fuel cell performance. Graphite plates with various flow field or flow channel designs, from literature survey and also novel designs by the authors, were used for the PEM fuel cell assembly. The fabricated fuel cells all have an effective membrane area of 23.5 cm2. The results showed that the serpentine flow channel design is still favorable, giving the best single fuel cell performance amongst all the studied flow channel designs. A novel symmetric serpentine flow field was proposed for relatively large size fuel cell application. Four fuel cell stacks each including four cells were assembled using different designs of serpentine flow channels. The output power performances of fuel cell stacks were compared and the novel symmetric serpentine flow field design is recommended for its very good performance.
10 June 2022 in Journal of Thermal Analysis and Calorimetry
The lithium–oxygen conversion chemistry relies on solid-electrolyte interface centered energy storage, rather than bulk considerations in intercalation chemistry. The electrochemical complexations in porous air electrodes are, however, a manifestation of coupled interface-transport-kinetic interactions. The non-equilibrium thermodynamics behind such multi-modal coupling, hitherto unappreciated, forms the central argument of this work. We comprehensively demonstrate the role of reciprocity between electrode architecture and off-equilibrium interactions in Li–O2 electrochemistry based energy storage.
1 January 2021 in International Journal of Hydrogen Energy
This article presents a study of the early detection of combustion instabilities of a liquid rapid premixed oil swirled burner. The main objective was the calculation of indexes, based on a chaotic analysis, able to detect in advance the combustion instabilities. In the combustor, the air mass flow rate was kept constant, and in order to induce the combustion instabilities, the fuel mass flow rate was adjusted during the experiments in which pressure and radiant energy fluctuations were simultaneously measured from the combustion chamber. In this chaotic analysis, joint recurrence plots were calculated in order to analyze the dependence between the pressure and radiant energy fluctuations. Hence, a diagonal-wise quantification was applied to the joint recurrence plots to calculate four indexes: the τ-recurrence rate index , the τ-determinism index , the τ-average diagonal line length index , and the τ-entropy index . The results show that all four indexes were capable of sorting all cases under analysis into two groups: the “combustion noise regime” due to the low-amplitude aperiodic oscillations and the “combustion instability regime” due to the high-amplitude periodic oscillations. In addition, early detection of the transitions were also detected. Therefore, the results presented in this research showed that the four indexes were effective precursors in order to detect in advance the combustion instabilities.
It is essential for electronics reliability to develop effective methodologies to detect hidden solder joint defects. Active infrared thermography is an alternative to X-ray detection methodologies. The limits of active infrared thermography to detect solder ball defects on plastic ball grid arrays (PBGA) components (missing, open, cracked, and head on pillow defects) are investigated here. A FEM was used to simulate the thermal phenomena during the infrared thermography inspection of a PBGA component. The FEM was proven to be temporal and spatial grids size independent. The average temperature difference (ΔT) amid regions with and without defects was used as a detectability indicator. Defects detectability was found to decrease as the number of blocking objects increases. Missing solder balls were barely detected when blocked by the substrate and moulding compound with detectability numbers close to 1 °C. Head on pillow and cracked defects were impossible to detect with a maximum ΔT = 0.6 °C. Open solder balls were not detected below two objects with a maximum ΔT = 0.3 °C. These results clearly suggest that infrared thermography can be effectively used to detect hidden missing and open solder ball defects on PBGA components composed by a substrate and a die.