The porous geopolymer has been tested for its content of water using impedance methods. The pores of the material were filled with distilled water using a desiccator and a vacuum pump. An analysis of differential scanning calorimetry (DSC) was carried out in the next step to check the content of water, porosity and approximate value of specific heat of the geopolymer. Additionally, mercury porosimeter has been used for checking the porosity. The geopolymer material characterized in this way was subjected to impedance tests aimed at developing a quick method for assessing the water content in the material. Impedance measurements have been realized on an electrochemical workstation applying a 50 mV non-destructive amplitude of the potential and a frequency range of 1 Hz to 100 kHz. Change in the module of impedance and the phase shift angle were measured while the material was dried out. Significant differences were observed. The obtained graphs were simulated using a schematic model consisting of constant phase elements (CPEs) and a resistor (R). These values showed mechanisms of charge conduction. A simple method for assessing the water content of a porous geopolymer has been proposed in this paper. The real and imaginary impedance values were shown in Nyquist graphs. These graphs have characteristic maxima that move according to a linear equation with decreasing water content. Changes in Nyqiust charts are clearly visible even with small changes in the water content of the material and can be very useful for assessing it.
This study investigates the physicochemical properties of hydrogels based on PVA and PVP crosslinked with PEGDA, focusing on their swelling capacity, surface roughness, incubation behavior, and structural modifications upon bioactive component incorporation. Swelling analysis demonstrated that the amount and molecular weight of PEGDA significantly influences the hydrogels’ sorption properties, with the highest swelling coefficient observed for samples with 2 mL PEGDA (575 g/mol) due to a looser network structure, while the lowest was recorded for 2.5 mL PEGDA (700 g/mol), indicating a denser network. Surface roughness analysis revealed that increasing the crosslinker amount led to higher roughness both before and after incubation, with samples containing 575 g/mol PEGDA being more susceptible to structural changes in an incubation environment. FT-IR spectroscopy confirmed the presence of characteristic functional groups, providing insight into the chemical stability and hydration properties of the hydrogels. Modification with a bioactive mixture (glucosamine, chondroitin, and MSM) was confirmed by spectral analysis, indicating successful integration without compromising the hydrogel matrix. The modified hydrogels demonstrated potential applications in regenerative medicine, particularly for joint disease treatment and cartilage tissue repair.
This paper presents the synthesis of fluorescein-modified hydrogel materials. The obtained materials were characterized using FT-IR spectroscopy. Then, their sorption capacity in distilled water and Ringer’s liquid was determined. Using digital microscopy, the morphology of the obtained systems was characterized.
The aim of this work was the synthesis of functional hydrogel materials obtained via photopolymerization. The resulting systems were characterized in terms of chemical structure using Fourier transform infrared spectroscopy. Subsequently, their sorption capacity and surface morphology were determined along with roughness analysis. The resulting materials have been modified with fluorescein dye and can be used in many branches of industry and medicine, for example, in innovative diagnostic systems.