This study develops an optimized femtosecond laser welding process for joining quartz glass and TC4 titanium alloy (Ti-6Al-4V) under non-optical contact conditions, specifically addressing the manufacturing needs of specialized photoelectric effect research containers. The joint primarily consists of parallel laser-welded zones (WZ) interspersed with base material. The defocus distance of the femtosecond laser predominantly influences the depth and phase composition of the WZ, while the weld spacing influences the crack distribution in the joint region. The maximum shear strength of 14.4 MPa was achieved at a defocusing distance of +0.1 mm (below the interface) and a weld spacing of 40 μm. The XRD stress measurements indicate that the defocusing distance mainly affects the stress along the direction of laser impact (DLI), whereas the weld spacing primarily influences the stress along the direction of spacing (DS). GPA results demonstrate that when the spacing is less than 30 μm, the non-uniform shrinkage inside the WZ induces tensile stress in the joint, leading to significant fluctuations in DS residual stress and consequently affecting the joint’s shear strength. This study investigates the effects of process parameters on the mechanical properties of dissimilar joints and, for the first time, analyzes the relationship between joint residual strain and femtosecond laser weld spacing, providing valuable insights for optimizing femtosecond laser welding processes.
Fe36Mn21Cr18Ni15Al10 high-entropy alloy was fabricated by laser metal deposition (LMD), and its corrosion behavior in supercritical CO2 (S-CO2) at 500 °C and 25 MPa was investigated. The results show that a distinct layered corrosion structure was formed during exposure. An Al-rich oxide layer formed first at the oxide/substrate interface, while Cr-rich protective oxides subsequently developed and stacked, jointly providing the main corrosion resistance. With prolonged exposure, local degradation of the protective layer created outward diffusion pathways for Mn, leading to the formation of Mn-dominated oxides on the outer surface. Cross-sectional analysis further revealed the presence of a pronounced Cr/Mn-depleted zone beneath the oxide scale, whereas no obvious carburization was detected. These findings clarify the oxidation mechanism of the LMD-fabricated high-entropy alloy in S-CO2 and provide useful guidance for its potential application in advanced energy systems.
A solid welding between the yttrium aluminum garnet (YAG) and TC4 titanium alloy (TC4, Ti-6Al-4V) is employed with a burst-mode femtosecond laser for the first time. The width and depth of laser weld lines are influenced by laser power and amount of sub-pulses (ASP), which correlate with shear strength of the joints. Amorphization inside the YAG base material is observed in the joint with ASP of 1, while joints with larger ASPs retain damage-free condition. Phase composition of the weld zone (WZ) and heat affected zone (HAZ) in typical joints are systematically investigated with a transmitting electron microscope and electron back scattering diffraction device, based on which a joint formation model is proposed. The maximum shear strength of 36.8 MPa was achieved at a laser power of 150 mW and an ASP of 4. This study aims to propose a damage-free welding between YAG and TC4 for applications in photoelectric effect research.