14 April 2016 in Scientific Reports
Exhaled carbon monoxide (eCO) and fractional exhaled nitric oxide (FeNO) could reflect underlying inflammatory and oxidative stresses, which play important roles in pathogenetic pathways of metabolic syndrome (MetS). However, epidemiologic evidence was limited. We conducted a study in Wuhan-Zhuhai (WHZH) cohort of 3649 community participants to investigate the association between eCO, FeNO and MetS in both cross-sectional and prospective ways. The results showed that higher eCO and FeNO were associated cross-sectionally with a higher prevalence of MetS. The multivariable-adjusted odds ratios for MetS at baseline were 1.22 (95% confidence interval [CI]: 1.11 to 1.35) associated with per log eCO and 1.14 (95% CI: 1.00 to 1.30) associated with per log FeNO. During a follow-up of 3 years, 358/2181 new developed MetS cases were identified. Compared with lowest quartile of eCO and FeNO, the multivariable-adjusted risk ratios (95% CI) for MetS were 1.48 (1.06 to 2.06) related to the highest quartile of eCO. These findings remained consistent across sex but not smoking status, eCO was only associated with MetS in non-smokers when stratified by smoking status. In conclusion, our study demonstrated that eCO and FeNO were independently and positively associated with the prevalence of MetS cross-sectionally, while only eCO was positively related with the incidence of MetS prospectively.
25 June 2026 in SSRN Electronic Journal
A solid welding between the yttrium aluminum garnet (YAG) and TC4 titanium alloy (TC4, Ti-6Al-4V) is employed with a burst-mode femtosecond laser for the first time. The width and depth of laser weld lines are influenced by laser power and amount of sub-pulses (ASP), which correlate with shear strength of the joints. Amorphization inside the YAG base material is observed in the joint with ASP of 1, while joints with larger ASPs retain damage-free condition. Phase composition of the weld zone (WZ) and heat affected zone (HAZ) in typical joints are systematically investigated with a transmitting electron microscope and electron back scattering diffraction device, based on which a joint formation model is proposed. The maximum shear strength of 36.8 MPa was achieved at a laser power of 150 mW and an ASP of 4. This study aims to propose a damage-free welding between YAG and TC4 for applications in photoelectric effect research.