Paweł Tomtas

Dr. Paweł Tomtas


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 March 2021 in Energies
Verified
Journal Article
Open access
PDF file
PTPaweł Tomtas
Paweł Tomtas
ASAmadeusz Skwiot
Amadeusz Skwiot
ESElżbieta Sobiecka
Elżbieta Sobiecka
AOAndrzej Obraniak
Andrzej Obraniak
KŁKatarzyna Ławińska
Katarzyna Ławińska
TOTomasz P. Olejnik
Tomasz P. Olejnik
This paper presents simulation and bench test results for a special type of centrifugal pump that enables the transport of dispersive foaming liquids and simultaneous separation of the liquid phase. During the design phase, CFD (Computer Fluid Dynamics) simulations were performed using Ansys Fluent. The simulations covered changing the operating parameters of the pump (mass/volume flow rate), pressure analysis for the first impeller, and structural optimization of the pump components. In the second stage of the research, the pump and a measuring station were constructed to validate the results of the numerical simulations.

11 August 2021 in Energies
Verified
Journal Article
Open access
PDF file
TOTomasz P. Olejnik
Tomasz P. Olejnik
TMTymoteusz Mysakowski
Tymoteusz Mysakowski
PTPaweł Tomtas
Paweł Tomtas
RMRadosław Mostowski
Radosław Mostowski
Uneven air distribution in chamber dryers is a common and serious technological challenge. A study using CFD (Computer Fluid Dynamics) simulation, supported by measurements in a heat pump chamber dryer, confirmed irregular airflows. Performing simulations with modified settings and additional chamber modifications enabled the airflows to be visualized and optimized. It was shown that a modification of the chamber where a rotating disc had been used had a positive effect on the uniform distribution of air flows in the drying chamber. The modification significantly improves the energy balance of the beef drying process. Optimization of the process resulted in obtaining a high quality final product-beef jerky. This investigation proves that appropriate drying process control and introduced modifications enable high product quality and a safe level of water activity without the preservatives supplementation.

10 September 2025 in Sustainability
Verified
Journal Article
Open access
PDF file
TOTomasz P. Olejnik
Tomasz P. Olejnik
Józef CiułaJózef Ciuła
Józef Ciuła
PTPaweł Tomtas
Paweł Tomtas
IWIwona Wiewiórska
Iwona Wiewiórska
ESElżbieta Sobiecka
Elżbieta Sobiecka
This article describes the implemented technological solution of utilizing waste heat by upgrading the potato protein drying line and using energy recuperation in the drying plant. In this article, the technological sequence of the potato starch and potato protein production plant was analyzed and the identification of possible solutions that lead to a reduction in energy demand was described. The method of analyzing the processing data is based on existing models describing the flow of mass and energy fluxes. The authors did not seek new mathematical descriptions of the physicochemical phenomena occurring during the drying processes, and only modification of the technological line based on the current state of knowledge in process engineering has been proposed. The full heat recovery of the production line was applied, and the exhaust air after drying and the heat from the decanter leachate after centrifugation of the coagulated potato protein, from two energy-coupled starch dryers, were used as the source of recovered heat energy. Temperature measurements were taken at key process nodes, and the energy effects were estimated after the process line upgrade. The solution proposed in the article fits with circular economy, bringing notable economic and environmental benefits consisting of utilizing waste heat from technological processes in the food industry.