High temperature treatment is a typical detrimental situation that may significantly influence the compressive strength of cement-based materials. It was reported that the incorporation of common waste materials as supplementary cementitious materials (SCMs) can improve high temperature resistance. In this work, fly ash (FA), granulated blast-furnace slag (GGBFS), and silica fume (SF) were used as SCMs to replace cement to produce green cement-based materials. The mechanical strengths of the samples being subjected to various elevated temperatures were measured and analyzed with different SCMs contents. Results showed that when the high temperature was above 500 °C, it caused significant loss of strength, and the use of SCMs can improve the high temperature resistance of the cement-based materials with higher residual strength, especially for the GGBFS and SF blended samples. Moreover, the random forest regression algorithm was used to predict the compressive strength for the cement-based material incorporating various waste materials, and exhibited high accuracy. This work presents a comprehensive study on the regularity of changes of mechanical strength and provides a specific algorithm for the precise prediction of this occurrence, which is helpful to understand and predict the influence of high temperature treatment on green cement-based materials with various waste materials.
Winter concrete construction is a pivotal engineering issue that needs to be addressed due to the failure of cementitious materials to hydrate under severely low temperatures. To solve the problem, the electric-induced heating curing (EIH) method was presented to prepare cement mortar (CF-CM) at an environmental temperature of −20 °C. The influence of some key parameters, including carbon fiber (CF) content (0–0.9 vol%), preparation methods, and EIH curing regimes (constant power vs. constant voltage; frequency: 30–70 Hz), on the performance of CF-CM were examined. Furthermore, the curing temperature of EIH-cured specimens were simulated based on COMSOL Multiphysics software. The results demonstrated that the electrical percolation threshold of CFs inside the specimen was 0.6 vol%. EIH curing achieved 1-day early strength equivalent to 2 days of standard curing, and increasing CF content showed little influence on the mechanical properties of CF-CM specimens. Moreover, constant-power EIH maintained stable curing temperatures (>50 °C), outperforming unstable constant voltage curing. Applied frequency (30–70 Hz) exhibited negligible impact on compressive strength, validating standard 50 Hz AC for practical application. Furthermore, the optimal EIH power density identified based on COMSOL Multiphysics software was 667 W/m2, successfully maintaining specimen temperatures between 60 °C and 70 °C to enable rapid strength development under sub-zero conditions, laying a foundation for the use of COMSOL in the guidance of EIH curing regime design. This work provides a scientifically grounded and applicable solution for winter concrete construction.