Na Zhang

Prof. Na Zhang


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 April 2025 in Processes
Verified
Journal Article
Open access
PDF file
NZNa Zhang
Na Zhang
MZMohammed Sulaiman Ebrahim Zaid
Mohammed Sulaiman Ebrahim Zaid
LTLei Tao
Lei Tao
Wenyang ShiWenyang Shi
Wenyang Shi
WLWenxin Li
Wenxin Li
WLWenlong Lu
Wenlong Lu
Tea saponin is a kind of natural non-ionic surfactant. Saponins were extracted from tea seed cake using an ultrasonic-assisted enzymatic method. The optimization of the tea saponin extraction procedure was conducted by using the response surface method to increase the yield. Study results indicated that the maximum yield of tea saponin was 69.81 mg/g under the optimum conditions of an enzyme concentration of 0.67%, a solvent-to-material ratio of 16.82 mL/g, an extraction temperature of 58.14 °C and an extraction time of 1.89 h. The surface activity experimental study results indicated that the critical micelle concentration of tea saponin was 0.5 g/L at 30 °C, and the lowest surface tension was 39.61 mN/m. The surface tension and CMC of tea saponin remained basically unchanged between 30 °C to 60 °C. When the pH of the solution was slightly acidic, the surface tension of tea saponin decreased significantly, while the CMC remained almost unchanged. Tea saponin has good salt and hard water resistance, and its surface tension decreases to a certain extent in both saltwater and hard water. The foam volume of tea saponin can reach 490 mL, with a half-life of 2350 s, and the foam is relatively stable. The combination of tea saponin and other surfactants has a certain synergistic effect. The critical micelle concentration of its complex system with the natural surfactant rhamnolipids can increase by 69.23%, and the surface tension can be reduced to a minimum of 22.56 mN/m. Moreover, by using the proposed method, the foam performance and stability of the system have been improved to a certain extent. This has significant practical significance for fully utilizing and developing waste camellia dried cake resources.

26 October 2025 in Gels
Verified
Journal Article
Open access
PDF file
ZXZhengxiao Xu
Zhengxiao Xu
MSMing Sun
Ming Sun
LTLei Tao
Lei Tao
Jiajia BaiJiajia Bai
Jiajia Bai
Wenyang ShiWenyang Shi
Wenyang Shi
煜彭煜耀 彭
煜耀 彭
At present, most oilfields in China have entered the late, high-water-cut stage, commonly facing declining single-well productivity and increasingly pronounced reservoir heterogeneity. Prolonged waterflooding has further exacerbated permeability contrast, yielding complex, hard-to-produce residual-oil distributions. Accordingly, the development of efficient enhanced oil recovery (EOR) technologies has become a strategic priority and an urgent research focus in oil and gas field development. Weak gels, typical non-Newtonian fluids, exhibit both viscous and elastic responses, and their distinctive rheology shows broad application potential for crude oil extraction in porous media. Targeting medium–high-permeability reservoirs with high water cut, this study optimized and evaluated a weak gel system. Experimental results demonstrate that the optimized weak gel system achieves remarkable oil displacement performance. The one-dimensional dual-sandpack flooding tests yielded a total recovery of 72.26%, with the weak gel flooding stage contributing an incremental recovery of 14.52%. In the physical three-dimensional model experiments, the total recovery reached 46.12%, of which the weak gel flooding phase accounted for 16.36%. Through one-dimensional sandpack flow experiments and three-dimensional physical model simulations, the oil displacement mechanisms and synergistic effects of the optimized system in heterogeneous reservoirs were systematically elucidated from macro to micro scales. The optimized system demonstrates integrated synergistic performance during flooding, effectively combining mobility control, displacement, and oil-washing mechanisms. Macroscopically, it effectively strips residual oil in high-permeability zones via viscosity enhancement and viscoelastic effects, efficiently blocks high-permeability channels, diverts flow to medium-permeability regions, and enhances macroscopic sweep efficiency. Microscopically, it mobilizes residual oil via normal stress action and a filamentous transport mechanism, improving oil-washing efficiency and increasing ultimate oil recovery. This study demonstrates the technical feasibility and practical effectiveness of the optimized weak gel system for enhancing oil recovery in heterogeneous reservoirs, providing critical technical support for the efficient development of medium–high-permeability reservoirs with high water cut.

21 July 2021 in Geofluids
Verified
Journal Article
Open access
PDF file
LTLei Tao
Lei Tao
XYXiao Yuan
Xiao Yuan
HCHao Cheng
Hao Cheng
BLBingchao Li
Bingchao Li
SHSen Huang
Sen Huang
NZNa Zhang
Na Zhang
SAGD (steam-assisted gravity drainage) technique is one of the most efficient thermal recovery technologies for exploiting Mackay River thin layer oil sand reservoirs. However, when making use of the traditional SAGD technique (the production and injection well are located on the same axis with the horizontal well spacing of 0 m), the steam chamber development is usually insufficient because of the high longitudinal sweep rate of steam, which seriously influences the SAGD performance for developing thin layer oil sand reservoirs especially. It is extremely important to find an economical and practicable method to promote the steam chamber development in thin oil sand reservoirs in the process of SAGD production; optimizing well placement is a reliable method. In this paper, an improved well placement method is proposed to enhance production performance of traditional SAGD, which is changing the horizontal well spacing to place the production well below of the side of the injection well (two wells are not located on the same axis). Three groups of 2D visualization experiments with different horizontal distances between two wells (0 cm, 10 cm, and 20 cm) were carried out, respectively, to observe the development and change of the steam chamber development, and to explore the EOR mechanisms. On the 2D experiment basis, optimal horizontal distance was selected to perform 3D physical simulation experiment to study and verity the production mechanism systematically. The results of 2D visualization experiment showed that the final oil recoveries of experimental groups with 10 cm and 20 cm horizontal distances were 7.6% and 2.3% higher than those of traditional SGAD (horizontal distance was 0 cm), respectively. Combined with 3D experimental results, the change in the horizontal relative position of two wells makes the steam first spread laterally between injecting and producing wells; thus, the lateral development of the steam chamber was promoted, and changes of temperature field also display that the lateral sweep area of steam was increased obviously and the form of steam chamber is changed. Meanwhile, the generation of appropriate horizontal well spacing can combine the effect of steam displacement and gravity drainage better and improve the sweep efficiency of steam. Nevertheless, the overlarge horizontal well spacing will also hinder the steam chamber development because the strength of steam overlap is weakened. Furthermore, the findings of this study help for better understanding that changing the horizontal well spacing can promote the lateral development of steam chamber, which can be used to enhance the oil recovery of thin layer oil sand reservoirs especially.

28 February 2023 in Petroleum Science and Technology
Verified
Journal Article
Closed access
LTLei Tao
Lei Tao
ZSZhiguo Sun
Zhiguo Sun
LZLi Zhang
Li Zhang
NZNa Zhang
Na Zhang
In high-temperature and high-salinity (HTHS) reservoirs, the performance of chemicals used in enhanced oil recovery (EOR) technology will be significantly affected by the temperature and salinity of formation water, resulting in the ineffective effect of chemicals. To solve the problem of low recovery in HTHS reservoirs, a new foam J4F6 was prepared. First of all, seven kinds of surfactant with good foam performance were selected on the base of widely used surfactants. Then matched the quality proportion of surfactant following the design, under the same conditions to evaluate their foaming performance and the ability to reduce the interfacial tension (IFT), J4F6 with the best performance was selected and then the concentration, NaCl, and Ca2+, temperature, aging time, and adsorption loss on the foaming performance were investigated. Finally, a sandpack flooding experiment was carried out to study the flow characteristics and resistance factor (RF) of J4F6. The results showed that J4F6 has the high strength adjustment and flooding ability of traditional foam. In addition, it has strong temperature and salt resistance, which can greatly improve the swept zone and oil displacement efficiency of HTHS reservoir and enhance oil recovery. This study can provide a reference value for EOR of HTHS reservoir.

20 December 2024 in Processes
Verified
Journal Article
Open access
PDF file
LTLei Tao
Lei Tao
GYGuangzhi Yin
Guangzhi Yin
Wenyang ShiWenyang Shi
Wenyang Shi
Jiajia BaiJiajia Bai
Jiajia Bai
ZXZhengxiao Xu
Zhengxiao Xu
LCLili Cao
Lili Cao
Aiming at the challenges of rapid heat dissipation, limited swept efficiency, and a rapid water cut increase in steam huff and puff development in heavy oil reservoirs, an alternating steam and CO2/viscosity reducer huff and puff method for IOR was proposed. In this work, the effect of CO2 on the physical properties of heavy oil was evaluated, and the optimal concentration of viscosity reducer for synergistic interaction between CO2 and the viscosity reducer was determined. Next, novel huff and puff simulation experiments by three sandpack models of different sizes in series were analyzed. Then, the IOR difference between the pure steam huff and puff experiments and the steam-alternating CO2/viscosity reducer huff and puff were compared. Finally, the CO2 storage rate was obtained based on the principle of the conservation of matter. The results show that the optimal viscosity reducer concentration, 0.8 wt%, can achieve a 98.5% reduction after combining CO2. The steam-alternating CO2/viscosity reducer huff and puff reached about 45 cm at 80 °C in the fifth cycle due to the CO2/viscosity reducer effects. CO2/viscosity reducer huff and puff significantly reduces water cut during cold production, with an ultimate IOR 15.89% higher than pure steam huff and puff. The viscosity reducer alleviates heavy oil blockages, and CO2 decreases oil viscosity and enhances elastic repulsion energy. The highest CO2 storage rate of 76.8% occurs in the initial stage, declining to 15.2% by the sixth cycle, indicating carbon sequestration potential. These findings suggest that steam-alternating CO2/viscosity reducer huff and puff improves heavy oil reservoir development and provides theoretical guidance for optimizing steam huff and puff processes.

25 November 2024 in Journal of Energy Resources Technology, Part B: Subsurface Energy and Carbon Capture
Verified
Journal Article
Closed access
PDF file
LTLei Tao
Lei Tao
MWMengjun Wu
Mengjun Wu
NZNa Zhang
Na Zhang
Wenyang ShiWenyang Shi
Wenyang Shi
LCLili Cao
Lili Cao
QZQingjie Zhu
Qingjie Zhu
In the late stage of exploiting heavy oil reservoirs with edge-bottom water, we are faced with problems such as high crude oil viscosity, channeling of bottom water, and rapid rise in water cut. To clarify the synergistic effect of N2, CO2, N2 foam, and viscosity reducer in water control and oil increase, and solve the problem of edge-bottom water rushing into production wells, one-dimensional sand-pack huff and puff experiments were carried out. First, the N2 foam huff and puff experiment evaluated the effect of N2 foam on controlling bottom water. Then the viscosity reducer assisted CO2 huff and puff experiment analyzed the synergistic viscosity reduction ability between the two to mobilize the remaining heavy oil. Next, the N2 foam-viscosity reducer-CO2 huff and puff experiment clarified the synergistic effect between the three. Finally, the N2 foam-viscosity reducer-CO2-N2 huff and puff experiment solved the problem of insufficient reservoir energy based on synergistic precipitation and oil increase. Experimental results show that N2 foam-viscosity reducer-CO2-N2 huff and puff is the optimal water control and oil increase solution. This solution can significantly reduce water production and increase oil production. In the one-dimensional sand-pack experiment, this technical solution reduced the water content by 68% and increased the recovery rate by 16.09%. The research results provide a reference for the development of exploitation technology schemes for similar edge-bottom water heavy oil reservoirs after entering high water cut.