The thermochemical process of gasification is widely utilized for bioenergy production and is particularly attractive due to its high conversion efficiency. However, a gasification byproduct, known as char, is commonly treated as industrial waste despite its attractive qualities. Indeed, due to its high carbon content (up to 91%) and well-developed porosity (specific surface areas up to 1253 m² g⁻¹), gasification char could be considered a cost-effective substitute for activated carbon in various applications, such as catalysis and adsorption. However, its properties are highly dependent on the gasification parameters and the initial feedstock selected, and thus a careful characterization of the material is needed to find the most suitable applications. This review can act as a preliminary assessment of the gasification along with the expected char properties, aiding in the selection of the most appropriate valorization pathways. In particular, different application areas, their relation to the gasification process, and the char properties are extensively discussed.

Liquefied natural gas (LNG) is increasingly used as a marine fuel due to its capacity to significantly reduce emissions of particulate matter, sulfur oxides (SO_x), and nitrogen oxides (NO_x), compared to conventional fuels. In addition, LNG combustion produces less carbon dioxide (CO₂) than conventional marine fuels, and the use of non-fossil LNG offers further potential for reducing greenhouse gas emissions. However, this benefit can be partially offset by methane slip—the release of unburned methane in engine exhaust—which has a much higher global warming potential than CO₂. This study presents an experimental evaluation of methane emissions from a RoPax vessel powered by low-pressure dual-fuel four-stroke engines with a direct mechanical propulsion system. Methane slip was measured directly during onboard testing and combined with a year-long analysis of engine operation using an Engine Load Monitoring (ELM) method. The yearly average methane slip coefficient (C_slip) obtained was 1.57%, slightly lower than values reported in previous studies on cruise ships (1.7%), and significantly lower than the default values specified by the FuelEU (3.1%) Maritime regulation and IMO (3.5%) LCA guidelines. This result reflects the ship’s operational profile, characterized by long crossings at high and stable engine loads. This study provides results that could support more representative emission assessments and can contribute to ongoing regulatory discussions.

On-board emission measurements were conducted at the exhaust of a passenger ship operating under real-world conditions. The chemical composition of exhaust particulate emissions from a turbocharged four-stroke marine diesel engine, operated on Marine Gas Oil was studied. A variety of organic compounds, including alkanes, alkenes, alcohols, cycloalkanes, cycloalkenes, esters, ketones, carboxylic acids, etc., were analyzed. Alkanes were the most abundant organic compounds, followed by alkenes, esters, and alcohols. Emission factors for these compounds were determined under two operating conditions: low engine load (at berth at 400 rpm/4% load, and during port maneuvers at 800 rpm/14% load) and high engine load (during cruising at 1000 rpm, 68% load). A clear increase in organic-compound emission factors was observed at lower loads. The total particulate matter emission factors were between 0.02 and 0.03 g/kWh at high-load points and exhibited significant variability under low-load conditions, from 0.02 to 2.83 g/kWh. The effect of a marine fuel additive was evaluated in this study. Using this fuel additive resulted in a significant decrease in both particulate matter and organic-compound emission factors, especially at low engine loads. Furthermore, the marine fuel additive decreased the total emission factors (${EF}_{TOCs}$) by a factor of 56 under low-load conditions. For high loads, the additive had no effect on the EF_TOCs.