Yi-Chieh Hsu

Prof. Dr. Yi-Chieh Hsu

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 November 2018 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
YHYi-Chieh Hsu
Yi-Chieh Hsu
CTChung-Yi Ting
Chung-Yi Ting
LHLi-Sheng Hsu
Li-Sheng Hsu
JLJing-Yuan Lin
Jing-Yuan Lin
CCCharlie Chung-Ping Chen
Charlie Chung-Ping Chen

15 February 2020 in Energies
Verified
Journal Article
Open access
PDF file
JLJing-Yuan Lin
Jing-Yuan Lin
YHYi-Chieh Hsu
Yi-Chieh Hsu
YLYo-Da Lin
Yo-Da Lin
In this paper, a triangular spread-spectrum mechanism is proposed to suppress the electromagnetic interference (EMI) of a DC-DC buck converter. The proposed triangular spread-spectrum mechanism, which is implemented in the chip, can avoid modifying the printed circuit board of switching regulators. In addition, a lower ripple of output voltage of switching regulators and a better system stability can be realized by the inductive DC resistance (DCR) current sensing circuit. The chip is fabricated by using TSMC 0.18-μm 1P6M CMOS technology. The chip area including PADs is 1.2 × 1.15 mm2. The input voltage range is 2.7~3.3 V and the output voltage is 1.8 V. The maximum load current is 700 mA. The off-chip inductor and capacitor are 3.3 μH and 10 μF, respectively. The experimental results demonstrate that the maximum spur of the proposed DC-DC buck converter with the triangular spread-spectrum mechanism improves to 14dBm. Moreover, the transient recovery time of step-up and step-down loads are both 5 μs. The measured maximum efficiency is 94% when the load current is 200 mA.

1 June 2018 in Energies
Verified
Journal Article
Open access
PDF file
YHYi-Chieh Hsu
Yi-Chieh Hsu
JLJing-Yuan Lin
Jing-Yuan Lin
CCCharlie Chung-Ping Chen
Charlie Chung-Ping Chen
The red-green-blue light-emitting diode (RGBLED) driver with adaptive driving voltage and energy-saving (ADVE) technique is presented in this paper. To obtain the proper driving voltage, a dynamic output voltage selector is proposed. This approach tracks the reference voltage of a boost converter to achieve the appropriate output voltage of the boost converter. Hence, the power loss of the linear current regulator is reduced to improve the efficiency of whole system. Moreover, the chip area is saved by the proposed switching linear current regulator. This chip was fabricated using TSMC 0.35 μm 2P4M complementary metal-oxide-semiconductor (CMOS) technology. The active chip area is 0.3 mm2. The maximum driving current and operating frequency are 100 mA and 100 kHz, respectively. Compared with a conventional LED driver with fixed output voltage, the experimental results demonstrate that the power loss of the proposed LED driver with ADVE technique is reduced by over 58%.

1 July 2018 in Energies
Verified
Journal Article
Open access
PDF file
CTChung-Yi Ting
Chung-Yi Ting
YHYi-Chieh Hsu
Yi-Chieh Hsu
JLJing-Yuan Lin
Jing-Yuan Lin
CCChung-Ping Chen
Chung-Ping Chen
This paper proposes a single-stage asymmetrical half-bridge fly-back (AHBF) converter with resonant mode using dual-mode control. The presented converter has an integrated boost converter and asymmetrical half-bridge fly-back converter and operates in resonant mode. The boost-cell always operates in discontinuous conduction mode (DCM) to achieve high power factor. The presented converter operates simultaneously using a variable-frequency-controller (VFC) and pulse-width-modulation (PWM) controller. Unlike the conventional single-stage design, the intermediate bus voltage of this controller can be regulated depending on the main power switch duty ratio. The asymmetrical half-bridge fly-back converter utilizes a variable switching frequency controller to achieve the output voltage regulation. The asymmetrical half-bridge fly-back converter can achieve zero-voltage-switching (ZVS) operation and significantly reduce the switching losses. Detailed analysis and design of this single-stage asymmetrical half-bridge fly-back converter with resonant mode is described. A wide AC input voltage ranging from 90 to 264 Vrms and output 19 V/120 W prototype converter was built to verify the theoretical analysis and performance of the presented converter.

3 April 2023
Verified
Other
Open access
WTWei-Tien Tai
Wei-Tien Tai
CSChung-Wai Shiau
Chung-Wai Shiau
YLYong-Shi Li
Yong-Shi Li
YCYao-Li Chen
Yao-Li Chen
PCPei-Yi Chu
Pei-Yi Chu
KCKuen-Feng Chen
Kuen-Feng Chen
PDF - 172K, Supplementary Methods

23 September 2025 in Electronics
Verified
Journal Article
Open access
PDF file
CCChih-Tsung Chang
Chih-Tsung Chang
YHYi-Chieh Hsu
Yi-Chieh Hsu
KPKai-Jun Pai
Kai-Jun Pai
CCChia-Yi Chou
Chia-Yi Chou
FXFu-Hua Xu
Fu-Hua Xu
This paper proposes a novel electric wheelchair that uses the surface electromyographic signal (sEMG) signals generated by the occlusal muscles to control the wheelchair during occlusion, instead of the traditional electric wheelchair that requires users to use their hands or feet for control. In this work, the myoelectric signal controls the electric wheelchair so that users with limited mobility and paraplegia can operate the electric wheelchair using the myoelectric signal generated during clenching. This is achieved through the seamless transmission of user data and GPS paths to the cloud and is facilitated by the state-of-the-art Wi-Fi 6E communication technology. By leveraging cloud connectivity, the system can instantly relay critical information, such as the user’s location and movement patterns, ensuring a prompt emergency response. Furthermore, several standard methods exist to set up the myoelectric signal electrodes and analyze the signals. This novel electric wheelchair can change the daily activities of many users who have difficulty walking. This work is presented as a proof-of-concept feasibility study rather than a comprehensive clinical validation.