This paper presents a gaseous oxygen detection system based on time-resolved phosphorimetry (time-domain), which is used to investigate O optical transducers. The primary sensing elements were formed by incorporating iridium(III) and palladium(II) meso-tetrakis(pentafluorophenyl)porphyrin complexes (IrTFPP-CO-Cl and PdTFPP) in polystyrene (PS) solid matrices. Probe excitation was obtained using a violet light-emitting diode (LED) (low power), and the resulting phosphorescence was detected by a high-sensitivity compact photomultiplier tube. The detection system performance and the preparation of the transducers are presented along with their optical properties, phosphorescence lifetimes, calibration curves and photostability. The developed lifetime measuring system showed a good signal-to-noise ratio, and reliable results were obtained from the optodes, even when exposed to moderate levels of O. The new IrTFPP-CO-Cl membranes exhibited room temperature phosphorescence and moderate sensitivity: <>/<> ratio of ≈6. A typically high degree of dynamic phosphorescence quenching was observed for the traditional indicator PdTFPP: <>/<> ratio of ≈36. Pulsed-source time-resolved phosphorimetry combined with a high-sensitivity photodetector can offer potential advantages such as: (i) major dynamic range, (ii) extended temporal resolution (/[O]) and (iii) high operational stability. IrTFPP-CO-Cl immobilized in polystyrene is a promising alternative for O detection, offering adequate photostability and potentially mid-range sensitivity over Pt(II) and Pd(II) metalloporphyrins.
1 January 2021 in Procedings Do Xv Simpósio Brasileiro de Automação Inteligente
Identificar defeitos assim que eles ocorram é uma estratégia essencial para garantia da qualidade dos produtos e para evitar perdas no processo produtivo. A identificação de defeitos na fonte ao invés da detecção após o valor adicional ter sido agregado tem crescido na indústria recentemente, especialmente com o avanço da tecnologia no contexto da Indústria 4.0. Este artigo visa especificamente desenvolver uma solução error proofing utilizando o framework DMAIC como processo de melhoria e o FMEA como ferramenta de engenharia. Após utilizar o framework para mapear o processo, foi escolhido um modo de falha para correção através de um sistema de visão. Os resultados gerados por esse experimento se mostraram satisfatório. O modelo proposto poderá ser explorado por profissionais e estudantes que buscam identificar perdas e elimina-las nos processos de negócios