Turbines are rotating machines that generate power by the expansion of a fluid; due to their characteristics, these turbomachines are widely applied in aerospace propulsion systems. Due to the clearance between the rotor blade tip and casing, there is a leakage flow from the blade pressure to the suction sides, which generates energy loss. There are different strategies that can be applied to avoid part of this loss; one of them is the application of so-called desensitization techniques. The application of these techniques on gas turbines has been widely evaluated; however, there is a lack of analyses of hydraulic turbines. This study is a continuation of earlier analyses conducted during the first stage of the hydraulic axial turbine used in the low-pressure oxidizer turbopump (LPOTP) of the space shuttle main engine (SSME). The previous work analyzed the application of squealer geometries at the rotor tip. In the present paper, winglet geometry techniques are investigated based on three-dimensional flowfield calculations. The commercial CFX v.19.2 and ICEM v.19.2 software were used, respectively, on the numerical simulations and computational mesh generation. Experimental results published by the National Aeronautics and Space Administration (NASA) and data from previous works were used on the computational model validation. The parametric analysis was conducted by varying the thickness and width of the winglet. The results obtained show that by increasing the winglet thickness, the stage efficiency is also increased. However, the geometric dimension of its width has minimal impact on this result. An average efficiency increase of 2.0% was observed across the entire turbine operational range. In the case of the squealer, for the design point, the maximum efficiency improvement was 1.62%, compared to the current improvement of 2.23% using the winglet desensitization technique. It was found that the proposed geometries application also changes the cavitation occurrence along the stage, which is a relevant result, since it can impact the turbine life cycle.
Turbines are rotating machines that generate power by the expansion of a fluid; due to their characteristic these turbomachines are widely applied in the aerospace propulsion systems. Since due to the clearance between rotor blade tip and casing, there is a leakage flow from blade pressure to suction sides, which generates an energy loss. There are different strategies that can be applied to avoid part of this loss, one of them is by the application of the called desensitization techniques. The application of these techniques on gas turbines have been widely evaluated, however, there is a lack of these analyzes for hydraulic turbines. This work is a sequence of previous analyzes developed for the first stage of the hydraulic axial turbine used on the Space Shuttle Main Engine (SSME) Low Pressure Oxidizer Turbopump (LPOTP). The last work analyzed the application of squealer geometries at rotor tip. In the present paper, the winglet geometry techniques were investigated based on three-dimensional flowfield calculation. The commercial CFX v.19.2 and ICEM v.19.2 software were used, respectively, on the numerical simulations and computational meshes generation. Experimental results published by the National Aeronautics and Space Administration (NASA), and data from previous works, were used on the computational model validation. The parametric analysis was done by the variation in the winglet thickness and width. The results obtained shown that increasing the winglet thickness, the stage efficiency is also increased. However, its width geometrical dimension almost does not impact this result. It was verified an efficiency increase of 2.0%, over the entire turbine operational range. It was found that the proposed geometries application also changes the cavitation occurrence along the stage, which is a relevant result, since it can impact the turbine life cycle.
The aim of this work is the application of desensitization techniques on the tip region of the turbine blade used in turbopumps applications. It is worth to study this region of the turbine because it has influence in turbomachines performances. Given the complexity of the tip geometries analyzed, structured meshes automatic generation is not feasible, therefore it is necessary to
This work presents the implementation of an interactive learning platform for turbine design in an engineering teaching environment. Due to the abundance of strategies and problems encountered in a multidisciplinary iterative design process, presenting the student to the multitude of scenarios can be a laborious and time-consuming task, often not possible in one-semester courses