We describe a method for dynamic power control of a submillisecond pulsed electron beam in a “SOLO” type source with plasma cathode. The beam power is controlled by dynamic variation of the beam current amplitude with the corresponding low-inertia change in the concentration of emissive plasma. This method can be used to generate submillisecond electron beams of variable power (up to 10 MW at a maximum variation rate not exceeding 0.5 W/μs)—in particular, for the processing of various metallic materials with modification of their functional properties by controlled beam energy supply to the material surface.
25 June 2021 in IEEE Transactions on Plasma Science
In this article, the experimental and theoretical data are presented which demonstrate the possibility of controlling the specimen surface temperature during irradiation with a submillisecond electron beam produced by a plasma-cathode electron source. The specimen surface temperature is controlled by modulating the beam current via appropriate short-time variations in the emission plasma parameters. The temperature ripple factor, measuring less than 5% in our experiments, is defined as the product of the specimen surface temperature and the discretization degree of the beam current and its pulse duration. The efficiency of the method of temperature control is confirmed by numerical simulations. The proposed method opens the way to new applications of plasma-cathode electron sources in science and technology.
Using the example of an electron source with a plasma cathode based on a low-pressure arc discharge with grid stabilization of the cathode/emission plasma boundary and an open anode/beam plasma boundary, a mechanism is described for increasing the electrical strength of a high-voltage accelerating gap by introducing a series negative current feedback (NCF) in the accelerating interval, which makes it possible to level out uncontrolled bursts of the beam current during its pulse. The introduction of NCF is achieved by using a special electrode in the space of the plasma emitter connected through a resistance to the anode of the arc discharge, and the main task of which is to intercept accelerated ions penetrating into the emitter from the high-voltage accelerating gap, due to which the current of electron emission from the arc discharge plasma decreases by a value proportional to the ion current in the accelerating gap. Since most sources and accelerators of electrons with plasma cathodes based on discharges of various types have a similar principle of operation, the use of this method will not only expand the limiting parameters of the generated electron beams, but also increase the stability of the operation of such electron sources, and, accordingly, beam irradiation of various materials and products. Keywords: arc discharge, plasma cathode, electron source, electron beam, ion beam, negative feedback.
1 January 2022 in High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes
Hypereutectic silumin (AlSi20) was exposed to a submillisecond intense electron beam with current modulation on the SOLO plasma-cathode electron source. The beam current was modulated so that the AlSi20 surface was first heated to melting for 200 μs and then kept at 600°C for 400 and 800 μs. After such modulated irradiation, the alloy was analyzed to assess its strength, wear resistance, structure, and phase state. The analysis shows that the longer the alloy is kept at 600°C, the higher the alloy microhardness and wear resistance. After modulated irradiation with 600°C kept for 800 μs, the microhardness of AlSi20 increases 2.2 times, and its wear resistance increases 3.7 times. Within a depth of up to 60 μm, the surface structure of AlSi20 irradiated in this mode is composed of rapidly solidified cells, and likely, it is this cellular structure which is responsible for the increase in the mechanical and tribological properties of the alloy.