This paper presents a study of a combined modification of silumin, which included deposition of a ZrN coating on a silumin substrate and subsequent treatment of the coating/substrate system with a submillisecond pulsed electron beam. The local temperature on the samples in the electron-beam-affected zone and the thickness of the melt zone were measured experimentally and calculated using a theoretical model. The Stefan problem was solved numerically for the fast heating of bare and ZrN-coated silumin under intense electron beam irradiation. Time variations of the temperature field, the position of the crystallization front, and the speed of the front movement have been calculated. It was found that when the coating thickness was increased from 0.5 to 2 μm, the surface temperature of the samples increased from 760 to 1070 °C, the rise rate of the surface temperature increased from 6 × 107 to 9 × 107 K/s, and the melt depth was no more than 57 μm. The speed of the melt front during the pulse was 3 × 105 µm/s. Good agreement was observed between the experimental and theoretical values of the temperature characteristics and melt zone thickness.
High-entropy alloys (HEAs) are a new class of materials consisting of at least five elements in equiatomic or near-equiatomic ratio. HEAs are subjected to various types of surface treatment to improve their properties. One of the most promising methods of surface hardening is electron beam processing. This study aims to examine the structure, elemental, and phase composition of the AlCrFeCoNi HEA surface layer after the deposition of a (B + Cr) film and irradiation with a pulsed electron beam. HEA samples of non-equiatomic composition (33.4 Al; 8.3 Cr; 17.1 Fe; 5.4 Co; 35.7 Ni, at. %), fabricated by wire-arc additive manufacturing (WAAM), were used as study objects. Modification of the HEA surface layer was carried out by a complex method combining deposition of (B + Cr) film samples on the surface and irradiation with a pulsed electron beam in an argon medium. The mode of modification was identified. It makes it possible to increase microhardness (almost two times) and wear resistance (more than five times), reduce the friction coefficient of the HEA surface layer by 1.3 times due to the decrease in the average grain size, formation of particles of borides and oxyborides of complex elemental composition, the introduction of boron atoms into the crystal lattice of HEA.
Hypereutectic silumin (AlSi20) was exposed to a submillisecond intense electron beam with current modulation on the SOLO plasma-cathode electron source. The beam current was modulated so that the AlSi20 surface was first heated to melting for 200 μs and then kept at 600°C for 400 and 800 μs. After such modulated irradiation, the alloy was analyzed to assess its strength, wear resistance, structure, and phase state. The analysis shows that the longer the alloy is kept at 600°C, the higher the alloy microhardness and wear resistance. After modulated irradiation with 600°C kept for 800 μs, the microhardness of AlSi20 increases 2.2 times, and its wear resistance increases 3.7 times. Within a depth of up to 60 μm, the surface structure of AlSi20 irradiated in this mode is composed of rapidly solidified cells, and likely, it is this cellular structure which is responsible for the increase in the mechanical and tribological properties of the alloy.