The paper proposes a SOC (State of Charge) estimation method for lead–carbon batteries based on the GA-MIUKF algorithm. The GA-MIUKF algorithm combines GA (Genetic Algorithm) for global search and optimization with the MI-UKF (Multi-innovation Unscented Kalman Filter) algorithm for estimating the SOC of lead–carbon batteries. By establishing an equivalent circuit model for the battery, the GA is employed to globally search and optimize the battery model parameters and the noise variance parameters in the MI-UKF algorithm. Comparative analyses with the UKF (Unscented Kalman Filter) algorithms and MI-UKF algorithms reveal that the SOC estimation method based on the GA-MIUKF algorithm yields more accurate results for lead–carbon battery SOC estimation, with an average estimation error of 2.0%. This highlights the efficacy of the proposed approach in enhancing SOC estimation precision.
In electric vehicles (EVs), bidirectional DC/DC(Bi-DC/DC) is installed between the battery pack and the DC bus to step up the voltage. In the process of mode switching under step signal, the Bi-DC/DC will be affected by a large current inrush which threatens the safety of the circuit. In this paper, a Bi-DC/DC mode switching method based on the optimized Bézier curve is proposed. The Boost and Buck modes can be switched based on the proposed method with fast and non-overshoot switching performance. The experimental results show that the mode switching can be finished in 4 ms without overshoot based on the optimal switching curve.
In order to achieve DC voltage matching, on-board charging, and DC/AC power inversion, three independent power converters are often needed in traditional Distributed Power Converter (DPC) systems of electric vehicles (EVs): bidirectional DC/DC (Bi-DC/DC), AC/DC, and DC/AC. The requirement of electronic devices such as power switches, inductors, and capacitors make the converter costly and complicated in structure. In this paper, a power converter with multi-operating mode (PCMM) is presented. The proposed PCMM can work in Bi-DC/DC, AC/DC, and DC/AC modes. The state-space averaging model of PCMM considering resistance of Insulated Gate Bipolar Transistor (IGBT) and the inductor is presented. Based on this model, the transfer function of the system is derived and the controller is designed. The simulation and experimental results show that PCMM can meet the design target and verify the feasibility of the model. The measurement results show that the weight of PCMM proposed in this paper is reduced by 51.2% compared with the traditional structure.
Traditionally, basis weight control valve is driven by a constant frequency pulse signal. Therefore, it is difficult for the valve to match the control precision of basis weight. Dynamic simulation research using Matlab/Simulink indicates that there is much more overshoot and fluctuating during the valve-positioning process. In order to improve the valve-positioning precision, the control method of trapezoidal velocity curve was studied. The simulation result showed that the positioning steady-state error was less than 0.0056%, whereas the peak error was less than 0.016% by using trapezoidal velocity curve at 10 positioning steps. A valve-positioning precision experimental device for the stepper motor of basis weight control valve was developed. The experiment results showed that the error ratio of 1/10000 positioning steps was 4% by using trapezoidal velocity curve. Furthermore, the error ratio of 10/10000 positioning steps was 0.5%. It proved that the valve-positioning precision of trapezoidal velocity curve was much higher than that of the constant frequency pulse signal control strategy. The new control method of trapezoidal velocity curve can satisfy the precision requirement of 10000 steps.