Minimum geometric dilution of precision (GDOP) is desired for a high accuracy in the localization of an unknown node. The optimal placements for the access nodes (or sensing nodes) to achieve the minimum GDOP can be configured by combinations of symmetric cones or regular polyhedrons. The minimum GDOP occurs at the tips of the cones or the center of the polyhedrons. These points are referred to as the designated min-GDOP-points. To benefit the minimum GDOP, the unknown node needs to be at the min-GDOP-points. However, that is hardly the case in practice, because the unknown node could be anywhere in a 3-D working volume or a 2-D area. It is shown that the minimum value of GDOP is determined by the number of access nodes and the dimensions of the measurement, and it does not depend on the elevations of access nodes as long as the topology of the placement is not altered. This motivates the proposed design to use the elevations as an extra degree of freedom to improve the overall localization accuracy in the volume. The goal is to seek the optimal elevations of access nodes to reduce the averaged GDOP values over the volume while keeping the theoretical minimum GDOP value unchanged. The obtained solutions are verified by extensive simulations.
Due to copyright restrictions, the access to the full text of this article is only available via subscription.In this article, we investigate the information-theoretical performance of a cooperative orthogonal frequency division multiplexing (OFDM) system with imperfect channel estimation. Assuming the deployment of training-aided channel estimators, we derive a lower bound on the achievable rate for the cooperative OFDM system with amplify-and-forward relaying over frequency-selective Rayleigh fading channels. The bound is later utilized to allocate power among the training and data transmission phases. Numerical results demonstrate that the proposed power allocation scheme brings between 5 and 19% improvement depending on the level of signal-to-noise ratio and relay locations
In the zenith-horizon placement for achieving minimum geometric dilution of precision (GDOP), one access node or sensor is positioned along the z-axis, while the remaining nodes are placed symmetrically on a three-dimensional (3D) cone. This configuration yields the minimum GDOP at the cone’s tip, which we term the designated min-GDOP point. However, in practical localization applications, the unknown node is not necessarily located at this designated min-GDOP point; instead, it may be situated anywhere within an area. As a result, evaluating localization accuracy across the entire area, rather than at a single point, is more relevant. Averaged horizontal dilution of precision (HDOP) and GDOP across the region provide more meaningful metrics for system-wide performance than values computed only at a specific location. Although many recent positioning applications leverage multiple unmanned aerial vehicles (UAVs), many established fixed sensor deployments predate the widespread adoption of UAVs. This paper proposes a novel approach with a single UAV working in conjunction with existing fixed access nodes for positioning. This approach offers improved adaptability for fixed infrastructure while circumventing the expense of establishing entirely new UAV systems, thus providing a valuable compromise. We investigate the criteria of average HDOP and GDOP over the given area. The objective is to determine optimal UAV positions along the flight path that minimize the average HDOP and/or GDOP across the area. Due to the analytical complexity, we employ numerical methods. Our simulation results demonstrate that minimizing average HDOP and GDOP often requires different UAV positions, depending on the number of access nodes and the size of the area. Consequently, achieving simultaneous minimization of both metrics with a single UAV trajectory is generally infeasible. When minimizing the average HDOP with a small number of access nodes, aligning the UAV’s XY-plane angle with those of the stationary nodes, offset by , proves advantageous. This angular alignment becomes less critical as the number of access nodes increases. For scenarios where both HDOP and GDOP are important, UAV placement can be optimized by selecting appropriate trade-offs. Additionally, we quantify how increasing the number of access nodes improves the average HDOP and GDOP over the specified area.
Single-satellite geolocation achieves effective localization of ground electromagnetic interference (EMI) signals with a low cost compared to the multi-satellite counterparts. In such systems, the Doppler and Doppler rate are commonly exploited to extract the information of the ground EMI sources and the constrained Unscented Kalman filter (cUKF) is found effective to provide instantaneous EMI locations over time. In this letter, we address the benefit of exploiting Doppler acceleration in the underlying single-satellite geolocation problem, and point out that exploiting additional constraint on the altitude of the ground emitter provides enhanced EMI tracking performance. The importance of such constraint is more pronounced in the beginning of the tracking process, whereas removing such constraint after a short period of time does not compromise the performance. The effect of sampling rates on performance and the required time to converge are investigated
30 September 2020 in Peer-to-Peer Networking and Applications