Ruixuan Yang

Mr. Ruixuan Yang

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 January 2024 in IEEE Solid-State Circuits Letters
Verified
Journal Article
Closed access
SMShuaizhe Ma
Shuaizhe Ma
ZYZhenyu Yin
Zhenyu Yin
NRNianquan Ran
Nianquan Ran
YXYifei Xia
Yifei Xia
RYRuixuan Yang
Ruixuan Yang
DLDan Li
Dan Li
This letter presents a 100-Gb/s CMOS PAM-4 transimpedance amplifier (TIA) with multimilliampere maximum linear input current. A low-noise high-linearity TIA architecture is proposed, leveraging the reconfigurable front-end (FE) TIA and the continuous time linear equalizer (CTLE) synced at multiple gain modes. Implemented in a 28-nm CMOS technology, the TIA achieves bandwidth of more than 24 GHz with transimpedance gain of 65 dB $\Omega $ , while showing an acrlong IRN current density of 10.4 pA/ $\surd $ Hz. The maximum linear input current reaches 2.2 mApp and the total harmonic distortion (THD) is less than 3% for an output swing of 600 mV $_{\rm pp, {\mathrm{ diff}}}$ . The chip consumes power of 56 mW from 1.4 and 1.1-V supply.

4 November 2024 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
YYYuye Yang
Yuye Yang
HFHao Feng
Hao Feng
ZYZhenyu Yin
Zhenyu Yin
SMShuaizhe Ma
Shuaizhe Ma
JLJia Li
Jia Li
DLDan Li
Dan Li
In this brief, an on-chip AC coupled analog front-end circuit with asymmetric output stage is proposed for a pulsed direct time-of-flight LiDAR receiver. The AFE employs a novel on-chip AC coupled scheme for APD cathode bias voltage tuning in a cost-effective manner. A reverse current cancellation circuit helps the circuit recover rapidly under large input current. A transimpedance amplifier is designed for low noise which is desirable to process weak signals. An asymmetric output stage doubles the output swing under the same bias current compared to conventional current mode logic topology. This prototype chip is fabricated in a standard 180 nm CMOS process and the measurement results shows bandwidth, gain, input-referred noise current of 151 MHz, 102 dB $\Omega $ , and 3.51 pA/ $\surd $ Hz, respectively. The maximum differential output swing reaches $1.8~\rm V_{\textrm {pp,diff}}$ based on both electrical and optical measurement setup.

24 June 2025 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
RYRuixuan Yang
Ruixuan Yang
YDYiming Dang
Yiming Dang
YXYifei Xia
Yifei Xia
CLCailing Li
Cailing Li
DTDonghe Tu
Donghe Tu
DLDan Li
Dan Li
Targeting the low-cost demands of 50G PON infrastructure, a 28-nm CMOS EML driver is presented. A novel DC-guarded-stack (DG-Stack) output stage is proposed to solve the inconsistency between low and high frequency steady state for improved robustness. An overlapped concentric T-Coil (OC-T-Coil) is designed to enhance bandwidth with half the area. The laser and SOA bias circuits are also integrated to reduce system cost. With low power consumption of 373 mW in a compact 0.586-mm2 die area, this design achieves a 50-Gbps NRZ modulation with 2-Vpp single-ended output swing and 7-dB extinction ratio, delivering >11-dBm average launch power.

20 August 2025 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
SMShuaizhe Ma
Shuaizhe Ma
XLXi Liu
Xi Liu
NRNianquan Ran
Nianquan Ran
YXYifei Xia
Yifei Xia
YYYuye Yang
Yuye Yang
DLDan Li
Dan Li
Differential sensing in intensity modulation/direct detection (IM-DD) theoretically offers sensitivity advantages. However, the need for reverse bias restricts photodiodes (PD) to AC coupling with differential TIAs, causing noise, bandwidth degradation, and baseline wander, compromising the advantage of differential sensing. This letter introduces the CMOS stacked-differential optical receiver architecture that employs DC coupling to connect the PD cathode and anode, enabling differential signal reception and reverse bias without AC coupling’s drawbacks. Fabricated in a standard 180-nm CMOS process and coupled with a PIN PD, the receiver achieves a differential-mode OMA sensitivity of −18.5 dBm. Comparative single-ended measurements were also performed, demonstrating a 1.3 dB sensitivity advantage from differential signaling which closely aligns with theoretical predictions. Operating at a 3.3 V power supply voltage compatible with optical devices, the receiver consumes 89.1 mW, with 86.5 mW utilized by the signal channels, resulting in a power efficiency of 97%.

17 May 2025 in Micromachines
Verified
Journal Article
Open access
PDF file
RYRuixuan Yang
Ruixuan Yang
YDYiming Dang
Yiming Dang
JCJinhao Chen
Jinhao Chen
DLDan Li
Dan Li
FSFrancesco Svelto
Francesco Svelto
The emergence of the AI era driven by Large Language Models (LLMs) and the next-generation high-definition multimedia interface for immersive technologies (AR/VR/metaverse) have created an unprecedented demand for high-bandwidth interconnects. While optical communication systems provide a broad bandwidth, their relatively low power efficiency continues to limit their deployment in new applications. This work addresses the power efficiency challenges in CMOS optical transceiver design, leveraging the inherent cost and integration advantages of CMOS technology. After outlining the design principles for low-power optical transmitter (Tx) and receiver (Rx) design, we present a comprehensive design of a low-power optical transceiver chipset implemented in 28 nm CMOS. The Tx features a high-impedance asymmetric current-steering output stage with a stacked architecture that facilitates unipolar power supply operation for the efficient anode driving of a common-cathode VCSEL array and achieved a power efficiency of 1.59 pJ/bit. The Rx incorporates a tail-current-controlled Cherry–Hooper-based variable gain amplifier (VGA), which achieved a transimpedance gain that ranged from 68.4 to 78.5 dBΩ and a power efficiency of 1.06 pJ/bit. The Rx–Tx back-to-back measurements confirmed successful data transmission at 4 × 20 Gbps, which demonstrated an overall power efficiency of 2.65 pJ/bit.

2 June 2025 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
SMShuaizhe Ma
Shuaizhe Ma
XLXi Liu
Xi Liu
YXYifei Xia
Yifei Xia
CYChuanhao Yu
Chuanhao Yu
YYYuye Yang
Yuye Yang
DLDan Li
Dan Li
This brief presents a 10 Gb/s optical receiver frontend that aims to replace the traditional APD with transimpedance amplifier (TIA) with a cost-effective design combining a PIN-PD and a super low-noise TIA (S-TIA). The STIA employed in this study features both architecture and circuit innovation to reach the substantial noise reduction required. Additionally, an innovative on-chip integrated lownoise PD bias is proposed. According to the test results, the entire chip consumes 121 mW of power, achieves a gain of 92 dBΩ, a bandwidth of 5.3 GHz, an input noise of 259 nArms, and an input noise density of 3.6 pA/Hz. The receiver demonstrates an Optical Modulation Amplitude (OMA) of -26.2 dBm at 10 Gb/s with a Bit Error Rate (BER) of 1E-3.