4 November 2024 in IEEE Transactions on Circuits and Systems II: Express Briefs
In this brief, an on-chip AC coupled analog front-end circuit with asymmetric output stage is proposed for a pulsed direct time-of-flight LiDAR receiver. The AFE employs a novel on-chip AC coupled scheme for APD cathode bias voltage tuning in a cost-effective manner. A reverse current cancellation circuit helps the circuit recover rapidly under large input current. A transimpedance amplifier is designed for low noise which is desirable to process weak signals. An asymmetric output stage doubles the output swing under the same bias current compared to conventional current mode logic topology. This prototype chip is fabricated in a standard 180 nm CMOS process and the measurement results shows bandwidth, gain, input-referred noise current of 151 MHz, 102 dB $\Omega $ , and 3.51 pA/ $\surd $ Hz, respectively. The maximum differential output swing reaches $1.8~\rm V_{\textrm {pp,diff}}$ based on both electrical and optical measurement setup.
20 August 2025 in IEEE Photonics Technology Letters
Differential sensing in intensity modulation/direct detection (IM-DD) theoretically offers sensitivity advantages. However, the need for reverse bias restricts photodiodes (PD) to AC coupling with differential TIAs, causing noise, bandwidth degradation, and baseline wander, compromising the advantage of differential sensing. This letter introduces the CMOS stacked-differential optical receiver architecture that employs DC coupling to connect the PD cathode and anode, enabling differential signal reception and reverse bias without AC coupling’s drawbacks. Fabricated in a standard 180-nm CMOS process and coupled with a PIN PD, the receiver achieves a differential-mode OMA sensitivity of −18.5 dBm. Comparative single-ended measurements were also performed, demonstrating a 1.3 dB sensitivity advantage from differential signaling which closely aligns with theoretical predictions. Operating at a 3.3 V power supply voltage compatible with optical devices, the receiver consumes 89.1 mW, with 86.5 mW utilized by the signal channels, resulting in a power efficiency of 97%.
2 June 2025 in IEEE Transactions on Circuits and Systems II: Express Briefs
This brief presents a 10 Gb/s optical receiver frontend that aims to replace the traditional APD with transimpedance amplifier (TIA) with a cost-effective design combining a PIN-PD and a super low-noise TIA (S-TIA). The STIA employed in this study features both architecture and circuit innovation to reach the substantial noise reduction required. Additionally, an innovative on-chip integrated lownoise PD bias is proposed. According to the test results, the entire chip consumes 121 mW of power, achieves a gain of 92 dBΩ, a bandwidth of 5.3 GHz, an input noise of 259 nArms, and an input noise density of 3.6 pA/Hz. The receiver demonstrates an Optical Modulation Amplitude (OMA) of -26.2 dBm at 10 Gb/s with a Bit Error Rate (BER) of 1E-3.
1 January 2026 in IEEE Transactions on Circuits and Systems I: Regular Papers
1 November 2026 in IEEE Photonics Technology Letters