In this work, we synthesized highly porous 3D sponge‐like mesoporous (MP)‐Si@C composites using mass‐scalable method. The optimized MP−Si@C 1 composite electrode, provided a reversible capacity of 1887 mAh g−1 after 100 discharge−charge cycles with capacity retention of 83 % at the rate of 0.1 C. At high C‐rate the MP−Si@C 1 anode provided reversible capacity of 910 mAh g−1 after 1000 cycles. The MP−Si@C 1/LCO full cell provide a discharge capacity of 1515 mAh g−1 and it works well for 100 cycles. This outstanding electrochemical behavior of the MP−Si@C 1 composite electrode was accredited to the exclusive structure of interconnected Si nanoparticles and the presence of the outer C thin layer. The carbon layer served as a shield, an effective buffer layer to house the extreme volume expansion issue of Si during continuous cycling. The excellent performance of the MP−Si@C 1 composite demonstrated its high applicability as potential anode material for next‐generation LIBs.
Mesoporous carbon (N-CMK3) decorated with different amounts of SnO2 nanoparticles was prepared in a controllable manner by using an incipient wetness impregnation technique, followed by a chemical reduction process, for application as a supercapacitor. The results of the analysis demonstrated that the surface area and pore volume of N-CMK3 decorated with SnO2 continued to decrease after impregnation with increasing amounts of SnO2. The results of the electrochemical measurement proved that decoration of N-CMK3 with a suitable amount of SnO2 enhanced the specific capacitance of the electrodes. Among the SnO2@N-CMK3 (SNC) samples under investigation, 15-SNC with 15 wt% SnO2 delivered outstanding electrochemical performance with respect to specific capacitance and cycling stability. At a scan rate of 5 mV s−1, 15-SNC exhibited superspecific capacitance up to 344 F g−1 and long-term cyclability at a scan rate of 50 mV s−1 with 92.4% retention of its initial specific capacitance of 161 F g−1 after 5000 cycles.
Porous MnO2 microflowers with a hexagonal crystalline structure were facilely prepared at a low hydrothermal temperature of 90°C, without using any template or capping agent. The as-prepared MnO2 only presented an excellent detection ability for copper (II) by a square wave anodic stripping voltammetry in the presence of super P carbon black as conducting agent, and Nafion as binder. In the present work, to evaluate the detection ability of copper (II) in the MnO2 microflowers, chips of screen-printed electrodes (SPEs) having a polyurethane substrate, a silver working electrode, a carbon counter electrode, and a silver pseudoelectrode, were designed. Then, the SPEs chips were modified with MnO2 microflowers and/or super P carbon and used as electrochemical sensors for the detection of copper (II) present in water sources. From the measured results, the fabricated sensors with excellent copper detection in a linear range from 0.625nM to 15nM (R2=0.9737), and a low detection limit (0.5nM), high sensitivity (214.05μA/cm2 nM), and rapid response (180s) demonstrated high application potential for electrochemical sensors in the detection of copper in water resources.
SnO2@CMK‐3 composites with different SnO2 contents have been successfully synthesized using incipient wetness technique. Because of a high specific area and porosity, CMK‐3 enables facile penetration of SnCl4 solution inside. Accordingly, SnCl4 clusters confined in the CMK‐3 mesopores easily transform to SnO2 nanoparticles. The obtained SnO2@CMK‐3 composites show a high surface area in a range from 224.8 to 398.1 m2/g and good lithium storage properties. Among the resultant composites, the composite‐70 with 70 % of SnO2 shows the best electrochemical performance. At the rate of C/10, the composite‐70 electrode delivers an average discharge capacity of 678 mAh/g. At high rates such as 5C, and 10C the electrode still achieves a discharge capacity of 270, and 201 mAh/g, respectively. Even after 1000 cycles at the rate of C/2, the electrode maintains 67.8 % of the initial capacity.
To develop new composites as advanced anode materials for lithium-ion batteries, in the present study, we propose a facile technique to synthesize Sn/SnOx@CMK-3 nanocomposites. The non-carbonaceous components (two or three phases) present in the Sn-based composites are probably tuned by changing the exposure duration in the air atmosphere. When being used as an anode for LIBs, the resulted multi-phase composite, Sn/SnOx@CMK-3 showed superior electrochemical performances to two-phase composites such as Sn@CMK-3 and SnO2@CMK-3. Because of the synergy effect caused by Sn and SnOx, at a specific current of 100 mAg(-1) the Sn/SnOx@CMK-3 electrode supplied a high discharge capacity of 702.9 mAhg(-1) after 100 cycles. The facile synthesis technique for Sn/SnOx@CMK-3 can be considered as a role model for preparing other anode materials for LIBs.