This paper presents the history of the development of heterojunction silicon solar cells from the first studies of the amorphous silicon/crystalline silicon junction to the creation of HJT solar cells with novel structure and contact grid designs. In addition to explanation of the current advances in the field of research of this type of solar cells, the purpose of this paper is to show possible ways to improve the structure of the amorphous silicon/crystalline silicon-based solar cells for further improvement of the optical and electrical parameters of the devices by using of numerical simulation method and current hypotheses. This paper briefly describes the history, beginning from the first studies of and research of HJT-structure solar cells. It raises questions about the advantages and existing problems of optimization of HJT solar cells. The authors of this paper are proposing further ways of design development of HJT solar cells.

This paper reports on the optimization of fabrication parameters of a heterojunction silicon solar cell using computer simulations and comparison of the simulation data with experimental results. The optimization of the photovoltaic devices was performed with respect to the thicknesses of amorphous silicon layers. As a result, a reasonable correlation between the simulation data and experimental results is observed within the acceptable margin of error with respect to heterojunction silicon solar cells with efficiency exceeding 20%.

The formation of complex surface morphology of a multilayer structure, the processes of which are based on quantum phenomena, is a promising domain of the research. A hierarchy of pore of various sizes was determined in the initial sample of porous silicon by the atomic force microscopy. After film deposition by spray pyrolysis, ZnO nanoclusters regularly distributed over the sample surface were formed. Using the electron paramagnetic resonance (EPR) method it was determined that the localization of paramagnetic centers occurs more efficiently as a result of the ZnO deposition. An increase in the number of deposited layers, leads to a decrease in the paramagnetic center relaxation time, which is probably connected with the formation of ZnO nanocrystals with energetically stable properties. The nucleation and formation of nanocrystals is associated with the interaction of particles with an uncompensated charge. There is no single approach to determine the mechanism of this process. By the EPR method supplemented with the signal cyclic saturation, spectral manifestations from individual centers were effectively separated. Based on electron paramagnetic resonance and photoluminescence studies it was revealed that the main transitions between energy levels are due to oxygen vacancies and excitons.

The detection of particles with uncompensated charge and the determination of the features of their interaction during the formation of nanocrystals on substrates with a developed surface are an interesting area of research. The porous surface formed via the electrochemical etching of silicon acquired fractal properties as a result of the deposition of zinc oxide layers. Microscopy methods using different resolutions revealed a hierarchical structure of the surface, where each of the three consecutive levels contains uniformly distributed formations. The deposition of 20 layers of ZnO maximizes the concentration of nanocrystals at the pore boundaries, while the deposition of 25 layers leads to the formation of a continuous layer. The increase in photoluminescence intensity with an increase in the number of deposited layers is due to the saturation of surface nanostructures with electrons through several mechanisms. Electron paramagnetic resonance (EPR) studies have shown that the main mechanism of radiation recombination is the capture of electrons on oxygen vacancies. The different nature of the EPR saturation of the signal of interconnected paramagnetic centers revealed the formation of zinc oxide particles at the boundaries of pores with different sizes. The results of these studies of surface-active structures effectively complement the knowledge about sensory materials.

Optimization and Fabrication of Heterojunction Silicon Solar Cells Using an Experimental-Industrial Facility AK-1000 Inline

The article presents the results of a study concerning the influence of conditions of copper wires electric explosion on a dispersity of produced nanopowders. It was shown that the energy introduced into the wire being increased, the specific surface area grows and the size of produced nanopowders decreases.