We have developed a 1 kHz repetition picosecond laser system dedicated for intense terahertz (THz) pulse generation. The system comprises a chirped pulse amplification laser equipped with a Yb:YAG thin-disk amplifier. At room temperature, the Yb:YAG thin-disk regenerative amplifier provides pulses having energy of over 10 mJ and spectral bandwidth of 1.2 nm. The pulse duration achieved after passage through a diffraction grating pair compressor was 1.3 ps. By employing this picosecond laser as a pump source, THz pulses having a peak frequency of 0.3 THz and 4 µJ of energy were generated by means of optical rectification in an Mg-doped LiNbO₃ crystal.

A novel design for a contact grating device with an incorporated Fabry–Perot resonator is proposed for high-power terahertz (THz) light generation. We deposited a multilayer consisting of ${\mathrm{Ta}}_2{\mathrm{O}}_5$ and ${\mathrm{Al}}_2{\mathrm{O}}_3$ on a magnesium-doped stoichiometric ${\mathrm{LiNbO}}_3$ substrate and fabricated grating grooves on the outermost layer. The multilayer was designed such that conditions for a Fabry–Perot resonator were satisfied for light diffracted by the grating. Consequently, the fraction of light transmitted into the ${\mathrm{LiNbO}}_3$ substrate, i.e., the diffraction efficiency, was enhanced by the resonator. The diffraction efficiency of the fabricated device was 71%, which is close to the calculated value of 78% from the optimized design. THz light generation was also demonstrated with the contact grating device. The THz output of 0.41 μJ was obtained using near-infrared pump light of 2.7 mJ.

We demonstrate photoacoustic wave propagation with a plane wavefront in liquid water using a terahertz (THz) laser pulse. The THz light can effectively generate the photoacoustic wave in water because of strong absorption via a stretching vibration mode of the hydrogen bonding network. The excitation of a large-area water surface irradiated by loosely focused THz light produces a plane photoacoustic wave. This is in contrast with conventional methods using absorbers or plasma generation using near-infrared laser light. The photoacoustic wave generation and plane wave propagation are observed using a system with a THz free-electron laser and shadowgraph imaging. The plane photoacoustic wave is generated by incident THz light with a small radiant exposure of < 1 mJ/cm² and delivered 600 times deeper than the penetration depth of THz light for water. The THz-light-induced plane photoacoustic wave offers great advantages to non-invasive operations for industrial and biological applications as demonstrated in our previous report (Yamazaki et al. in Sci Rep 10:9008, 2020).

We investigated liquid-sheet jets with controllable thickness for application to terahertz (THz) spectroscopy. Slit-type and colliding-jet nozzles were used to generate optically flat liquid jets. The thickness of the liquid sheet was determined precisely by spectral interference and THz time-domain-spectroscopy methods. By adjusting the collision angle of the colliding-jet nozzle, we could control the thickness of the liquid sheet from 50 to 120 μm.

A novel technique for the terahertz (THz) tomography of a photo-induced carrier that is based on optical-pump THz-probe time-resolved reflection spectroscopy using counterpropagation geometry of the pump and probe pulses has been proposed. Transient reflection due to the photo-induced carrier provides information about the physical properties and spatial distribution separately. We have experimentally demonstrated this method using a silicon wafer. The obtained complex reflection can be reproduced by the exact solution of Maxwell’s equations, assuming an exponential distribution of the photo-induced carrier density.