18 July 2019 in Nature Communications
Dendrite arm fragmentation is considered in solidification structure tailoring. Time-resolved and in situ imaging using synchrotron radiation X-rays allows the observation of dendrite arm fragmentation in Fe–C alloys. Here we report a dendrite arm fragmentation mechanism. A massive-like transformation from ferrite to austenite rather than the peritectic reaction occurs during or after ferrite solidification. The transformation produces refined austenite grains and ferrite–austenite boundaries in dendrite arms. The austenite grains are fragmented by the liquid phase that is produced at the grain boundary. In unidirectional solidification, a slight increase in temperature moves the ferrite–austenite interface backwards and promotes detachment of the primary and secondary arms at the δ–γ interface via a reverse peritectic reaction. The results show a massive-like transformation inducing the dendrite arm fragmentation has a role in formation of the solidification structure and the austenite grain structures in the Fe–C alloys.
29 May 2015 in Optics Express
We have developed a 1 kHz repetition picosecond laser system dedicated for intense terahertz (THz) pulse generation. The system comprises a chirped pulse amplification laser equipped with a Yb:YAG thin-disk amplifier. At room temperature, the Yb:YAG thin-disk regenerative amplifier provides pulses having energy of over 10 mJ and spectral bandwidth of 1.2 nm. The pulse duration achieved after passage through a diffraction grating pair compressor was 1.3 ps. By employing this picosecond laser as a pump source, THz pulses having a peak frequency of 0.3 THz and 4 µJ of energy were generated by means of optical rectification in an Mg-doped LiNbO3 crystal.
15 January 2005 in Materials Science Forum
1 January 1990 in Physics Letters B
1 April 1992 in Surface Science
1 December 2010 in Key Engineering Materials
Although several computer simulation codes have been developed to predict and prevent defects of lost foam castings, most of them are focused on aluminum alloy castings. This paper presents a new simulation method suitable for not only aluminum alloy but also cast iron. First of all, main assumptions and numerical schemes are as below: 1) Gas flow in the mold follows the D’Arcy’s law. 2) The gas pressure in the kinetic zone (gas gap) is uniform in each gas group and is solved by using the flow field of melt one time-step before. 3) The gas obeys the ideal gas law. 4) Latent heats of evaporative pattern degradation are simplified by an overall latent heat in which both melting and evaporation are considered. 5) The pattern absorbs heat of melt through conduction, radiation and convection. Further, X-ray direct observations of mold filling behaviors of cast iron were carried out in order to better understand the physical fundamentals and to evaluate simulated results. It was found that: 1) Mold filling behaviors of cast iron are quite different from those of aluminum alloy castings depending on the gating system and thickness of the casting. 2) Bubble floating-up often occurred in the case of the downward flow. 3) Although the newly developed simulation code could predict the mold filling to some extent, further work needs to be done, including better understanding of the heat transfer mechanism between the melt and pattern.